20 Most Recent Frigidaire GLGH1642DS Front Load Stacked Washer / Dryer - Page 8 Questions & Answers

I don't understand SHANE circuit board. IF you replaced the board, it has been upgraded and you need to order a new wiring harness for it. Please post the model number

Check if your water supply is coming in very well

You probably have a broken door (or lid) switch. You will need to replace it, as they are usually cheap plastic, easily broken, and not too hard to replace. God bless your efforts.

Hey friend, thanks for your inquiry!

I see off your post your Frigidaire washer is showing a "PAU 12" code. Typically "PAU" stands for pause which means the cycle has been interrupted. I would open and close the door to assure that there is a proper connection between the door strike and door latch. If you check that and still receive the "PAU" I would recommend a reset, which can be done by flipping the household circuit breaker off for roughly ten minutes. Hopefully this is helpful. -Matt

Then I strongly suggest you hire a repair tech.

I just had the same E90 code with my "good model" Frigidaire washer. It beeps 9 times, then pauses and repeats. Nothing worked as far as resetting, unplugging,etc. HOWEVER, I saw this guy's video and his "hairdryer technique" worked perfectly.
https://youtu.be/IhHvw2K7XO0
I took it a step further by not only removing the two screws from the back of washer and the top cover, but also removing the front panel w/buttons by taking off two scews in front top corners and three scews inside the detergent drawer (take drawer out first). I moved the hairdryer back and forth over all the wire harnesses for about a minute, plugged it back in and it beeped once like normal. Put it all back together and it's running a load of wash now!! Good luck.

Look for a utensil blocking the arm from freely rotating. Look in the blade that rotates too; it pumps the water to the arm that rotates.