20 Most Recent U-Line Icemaker - Page 4 Questions & Answers

go to www.u-line.com/media/downloads/service/41921. then click on Service and parts manual-u-line it is a PDF it will have the wiring diagram

If unit is making ice and is melting before it fills bin up in 24 to 36 hours then it is taking to long to make ice. check the condenser coil and clean it out. if coil is dirty than it will take longer to make a batch of ice.

Check with meter to see if you have power to stat. if so then cut power off check the stat with ohm meter to see if contacts is closed assuming the box is warm if you do nothing wrong with the stat. if contact is open then replace it.

First take your meter and check to see if you have power going to your rocker switch if so then check to see if you have power going through the rocker switch or you can ohm the switch with out power applied to make sure switch is good, if switch is good then check the control switch power should be going to switch from rocker switch make sure power is going through control switch if so at this point you should have power to control board if so then replace control board.

www.u-line.com/ Make sure the condensor and fan are clean.

P1 is a indicator of a slow or clogged drain check to make sure that every thing is draining good if line is clear make sure pump is coming on to pump the water out of the bin. once all is clear unplug the unit for an hour then plug back in this will clear code unless you still have a drain issue.

Is it a case of needing to press and hold the on/off button for more than two seconds to turn it on?

If the water is pouring out from underneath, and you have a drain pump, check in back of the unit to see if the water tube has come away from the drain pump, therefore dumping the drain water on the floor. It happened to our unit because the unit moves a bit each time the door is opened or forcefully closed. Hope that helps!

If you have several faults with this icemaker, it might be better to call out a technician. Several problems posted for the same machine usually requires further investigation

The drop sensor is faulty, fooling the machine that the ice has harvested so it restarts. Eventually you will just have a solid block of ice. Replace sensor (magnetic reed switch)