20 Most Recent Maytag MGC2SC072D24B 72,000 BTU 92.1% Gas Furnace, 1 Stage, Questions & Answers

Google is your friend in such mystery questions Joseph :>D Google make model manual There may also be videos and reviews ..

If name tag is legible, check there. Guess 134a

Window AC units need to be leveled horizontally and slightly tilt back for proper drain purposes.

AC units don't need water, only evaporative coolers do.

Siphon it out with a hose.

no fan only doesn't run the compressor motor so it save money

5000 BTU

The switch or knob for that burner is shot. to disconnect that burner first see if there is a fuse that goes to just that burner and take it out. That should stop any power to that burner. If not take the knob out and undo the wires to that switch and put electrical mar rets on the wire ends. Just as a precaution put electrical black tape on the outside of the mar rets to make sure they do not come off. DO NOT try to put these wires back on the switch.

I cannot seem to find a manual. Have you emptied to drain ? If you need further help, reach me via phone at https://www.6ya.com/expert/thomas_092728000e6acb79

Sounds like the heater is on as well. Even if ac is not working it shouldn't get hotter than outside air temp. Possible stuck relay. If you need further help, reach me via phone at https://www.6ya.com/expert/thomas_092728000e6acb79

The orifice is too large. Make sure it's the correct one and that it matches the old one. On occasion, the orifice that shows to be the correct one could be wrong and you'll need the original one to determine which one you need.

If you have a dual capacitor, which has 3 posts, C - goes to Run on the compressor. Herm goes to start on the compressor. If you have a single capacitor Run from the compressor goes to the terminal on the capacitor that has a wire coming from one side of the contactor. The start wire goes to the other terminal on the capacitor without another wire attached to it.

The word herm means hermetically sealed compressor. That wire goes to the start terminal on the compressor.

look for a sticky tag on the back of the unit look for something with this (example only )Maytag: Model: NMPEB08F2A: MPN: CR with numbers