20 Most Recent HP LaserJet M4345 MultiFunction Printer Questions & Answers

Hi, Resetting the HP LaserJet Pro M1536dnf accomplishes the following:

• Clears all data from the printer's memory (including unprinted data, downloaded fonts, and macros).
• Stops any printing that is taking place and ejects the page.
• Removes some error conditions.
• Resets the printer to its factory default settings.

Reset Procedure:

• Turn off the printer
• Press and hold the Left arrow & Cancel while you turn on the printer
• Once you see Permanent Storage Init you can release the buttons.
• The printer should now start resetting.

Thanks, HP Printer Support

The tray lifting error is displayed as 60.02 Tray 2 lifting error. To fix this error, check the surface sensor of the paper tray2 in the Manual Sensor Test 2 menu under the Troubleshooting menu. Connect back the cassette lifter motor and the DC controller PCA's connectors and now, replace the filter driver unit in your printer. 123 hp com Quick HP Printers Setup Easy Installation Guidelines

It may be your ink you need to renew

13.20.00 can be also caused be a jam near the fuser (the part of the printer that gets hot to make the toner stick to the paper). Remove the toner cartridge and take a look for small scraps of paper along the whole path. Also open the door on the back of the printer and look for paper scraps from there. If you see paper stuck in the fuser, do not use anything sharp to remove it, be careful not to scratch the surfaces.

hp laserjet m1132 mfp errer E3

Calibrate the control panel

Use the following procedure to calibrate the control panel:

1. Turn the device off.

2. Press and hold the # key and the C key.

3. Turn the device on.

4. When a small white square appears in the upper-left corner of the control-panel display, touch

the square with a stylus.

5. When a small white square appears in the lower-left corner of the control-panel display, touch

the square with a stylus.

6. Allow the device to finish the boot process.

Hope this helps.

How to remove the error reattached output bin HP m4345mfp

I'm assuming that you're trying to scan to your computer.?? I'm not specifically knowledgeable about the HP M4345 printer.... but, it HAS to have a cable connection. The cable should be one that has a usb connection on one end, and a small kind of rectangular plug on the other that plugs into the back of the printer.. Look on the back of the printer. There has to be a connection, besides the jack for the 110 V.

my experience says jamming in duplex area using card stock. this may occur if default is duplexing. set default to single side and / or try same job using plain a4 80gm2

Where did you see that code?!!!!

Check the tray feed rollers

check the feed tyres, customer changeable

it might be the problem of cartridge drum is not rotating properly pls change the cartridge or change the main motor assembly

switch on the printer while memory counting press 3 then all led will glow stable then press 9 then start button u will find full nvram on display then press 6

58.04 error is an Engine Power Supply error. RM1-1041 is the part number for 110v RM1-1042 is the part number for 220v. You will need a tech to swap it out. You have to strip the printer down to get to the part.

Try initalizing the Harddrive if that doesn't work. Try replacing the scanner controlboard or the DC controller. Or if the MFP is in a dusty room try cleaning the lenses and mirrors in the scanner unit first

You're in luck! That was previously answered here: http://www.fixya.com/support/t9598231-error_49_4c2f_continue_restart