20 Most Recent Danby DWC283BLS Wine Cooler - Page 7 Questions & Answers

that's always a possibility but not always the case. The thermostat may not be cycling correctly or set wrong. The condenser could be dirty or if there is a fan, it may not be running. Freeze ups can also cause an "Out of temp." condition. Check it out.

ck tsta setting maybe move tsta thermal coupler to diff spot

Bad relay or compressor.

it may also be a blockage so look for a R/A engineer to check for both leakage and blockage.

you must try from insyde, all my model's have acces from inside. you dont have a seal, remove carrefuly to not bent somethig and it will be ok. I presume that fan is an tangetial fan (that kind of fan have all my wine cooler's) you will need a screwdriver phillips and maybe a wrench.

the mildewing is becouse its to damp there and it needs a lot more air to shift this damp away,,,i found the best thing to get rid of mildew is to wash every thing down using a strong mix of white vinegar,,, it works realy well on the inside of wooden boats??
its cheep too, it just smells like a chip shop for a day or so but it will work

Could be a defective thermostat, or you could have placed your cooler in a area without adequate ventilation.

Hi,

Hold ON. This is a Common Error on these Wine Coolers. As Per Danby, they do mention it is a " Sensor " Problem but

Hi



Thanks for using FixYa. To reset the unit you’ll need to switch it off, unplug the switch from the power socket and mains and let it off at least 8-10 hours to resolve the issue. If still the issue persists and as you are able to hear the compressor and fan working you’ll need to check that there is no leakage in the system. The top fan will only function when it’s too cold and the heater is in on position.

Please do accept the solution if the issue is resolved or else revert for further assistance.


Thanks

Rylee

the top fan is not suppose to run all thetime only when its too cold and the heater kicks then the top fan will come on,you probley have a leak in the system

No,you have a leak in the system.

not worth repairing , get new

The compressor needs to be tested to see if it's operational. This normally needs to be done by a service tec.

Disconnect the power cord from the wall outlet and wait 30 minutes before pluging back in. This should clear all settings on the cooler.

http://www.danby.ca/cms/uploads/products/en_manual/DWC283BLS.pdf

The problem is likely with one of the two fans. A new fan is available from Danby (1-800-263-2629). My noisy fan is the condensor fan located at the bottom rear of the device. After removing the cooler from under the cabinet, the source of the noise was obvious. You will need to tell them whether it is the upper fan or lower fan. Leave the cooler upright for a few hours before you plug it in so that you do not damage the condenser. Price for the fan from Danby is $20.15 including shipping. Users Manual is available at http://www.danby.com/manuals/DWC512BL.pdf -Ron

Hi,

YOU MIGHT HAVE A FAULTY COMPRESSOR (MOTOR) OR A GAS LEAK.LET ME NO IF YOU NEED FUTHER ASSISTANCE ALSO THE VENTALATION COULD CAUSE IT AS YOU SAY THAT IT IS BUILT INTO THE CABINITS SO REMOVE IT

OR

If the motor are running the gas level are too low . if the motor are not running check the thermostat. if there are power by the motor and stil not running then it is the motor

OR

Does the compressor run or shut off when it gets to 55 &57? Leave unplugged over night and try again..

Also a dusty coils could cause the problem . its very important to keep the coils clean

Thank You