20 Most Recent HP DesignJet 330 InkJet Printer - Page 2 Questions & Answers

There are three ways of configuring IP address on any HP Printer: A.- Using the control panel B.- Using the web server C.- Using the Jet Admin Utility We'll deal with the contro panel setup. To access the contro panel menus 1. Press OK (Check Mark) button once to access MENUS. 2. Press Up Arrow or Down Arrow buttons to navigate the listings. 3. Press OK (Check Mark) button to select the appropriate option. 4. Press Return to return to the previous level. 5. Press OK (Check Mark) button to exit the menus So to configure IP address: Press Check Mark Navigate to the CONFIGURE DEVICE Menu using Down Arrow (the menu scrolls, so you may use any combination of Up/Down arrows) Navigate to the I/O Menu Navigate to the EIO 1 menu Navigate to TCP/IP Navigate to BootP entry Press Check to disable it (Off) Press return Navigate to IP Address, press Check Use Up/Down buttons to change the address, check to move between octets. When finished, press Return In the same way, enter Mask and Default Gateway Press Return until you are out of the Menus. Done

If this is an HP LaserJet 5100, then the cartridge or the fuser need to be replaced.

run "clean heads" or replace color catrige.

there are a few fuses that are component based I.E. soldered to the circuit rather than a glass shaped fuse, I would recommend that if you have tried a second mains lead that you put a call into a hp representative or HP trained technician to see if its safe to just replace the fuse or if anything more has happened to cause the fuse to trip. wildly replacing fuses may cause more harm than good. the right choice is to have a trained tech called out.

again the carriage belt drive has chewed - the ONLY REPAIR IS TO REPLACE this belt ( 3rd time answering this same question) this machine is too old to get new parts for - good luck

80 ......... there is more to error code than just 80 please give full error code details for a useable solution . eg 86:01 ( carriage motor transport error) or 0c00340a is also a fault code if you can supplye either full error code then I will attempt to help you resolve it thanks

sounds like the service station siezed and the control circuit to the motor has burned out- common fault for this machine- unfortunately this means its cheaper to buy a new machine than it is to repair- sorry

replace the fuser unit

you will need to order the z6100ps hard drive and not the hpgl hard drive you may want to try re writing the eeprom using the diagnostics mode 9 from mainPCA to HDD although I'm fairly certain it will error out as its the wrong type of hard drive