Top 20
Konica Minolta bizhub 350 All-In-One Laser Printer Questions & Answers
I have a new used
When you installed the driver did you check the boxes for the installed options? Plus you may have to check the box for saddle unit. Hope this helps.
Jagged edges and misregistration
What printer is it ? Some older ones need manual calibration, where patterns are printed, then you tell the system which is the best one. Newer ones can self calibrate, but still need it done. Go into your printers menu and see if you can find something on calibration or allignment.
How to clear the error code 255?
Check the UN2 connector for proper connection and
correct as necessary.
- -
2
Remove the Developing Unit from the IU, and then
replace UN2.
- -
3 Run F8. - -
4 Change PWB-A - -
5 Change PU1
Why is it that the toner hopper is not rotating?
A few things could be wrong.
1. Check if the toner is not bad, all hard as a rock. If so replace it
2. Check to see if the toner bottle isn't dammaged. If so replace it.
3. The toner auger is clogged? Vacuum the whole toner hopper out so it empty then add a fresh new toner. If it adds toner you will know. If it doesn't then the ring the toner bottle sits in is siezed. Remove it and clean throughly.
3. If all that seems good your going to hafta get a new hopper unit.
Code c255c after the f8 function
if you have a C2557 after changing F8 developer then your extra toner is too strong. Check your clutch adding toner, replace the small foam with an equivalent thickness, increase your toner and repeat a gain F8.
How do I clear the error code C11A3?
Shutter unit defection.Press Utility key-Meter count-Check details-00000000-End and you entering in service mode,select trouble reset.The very simple method is remove the finisher/exit unit and work without.
My Adf its not working properly it scan only half of page.
This is simple. There are a bunch of sensors in the adf that read the paper size. Your adf is telling the copier that your copying 8.5x5.5 that's when the copier blanks out the rest of your page. So do u have any scrap of paper or sensor that is blocked they have spring loaded flags on them sometimes the spring will fall off and cause this so look very carefully and you will find the little sensor that is causing your problem. Also there are photo sencors that get dusty. So use canned air to clean them out but be careful you could knock off the springs on the flags with air.
Error code 5351
C5351 Power Supply Cooling Fan
Motor Failure
The Power Supply Cooling Fan Motor Lock signal
remains set to H for a set period of time while
the Power Supply Cooling Fan Motor is turning.
• The Power Supply Cooling Fan Motor Lock signal
remains set to L for a set period of time while
the Power Supply Cooling Fan Motor remains
stopped.
Not finding what you are looking for?