JCPenney Gyropter RC Helicopter - Answered Questions & Fixed issues
MY GYROPTER WILL NOT FLY.
I charged my gyropter ,and the bottom propeller spins slowly and makes a noise.
3/18/2014 1:00:07 AM •
JCPenney...
•
Answered
on Mar 18, 2014
•
1,992 views
I cHarged the helicopter and
try to play around with the trimmer.. i had the same problem but then guessed it was the trimmer and iwas right!
12/7/2013 9:00:18 PM •
JCPenney...
•
Answered
on Dec 07, 2013
•
1,052 views
The tail rotor will not
doubld blade rotor there is no need for a rear/tail rotor,
on the remote are 2 buttons they will control Left/Right
spin , adjust so that it does not spin around
12/28/2012 12:29:17 PM •
JCPenney...
•
Answered
on Dec 28, 2012
•
1,582 views
Chopper spins clockwise . How do I fix it
It is spinning around because one of the rotors is not spinning at full speed. This happens when you bump a spinning rotor against something. Determine which one it is by observation or logic (i.e, the one that turns clockwise will produce counterclockwise torque, which is to be balanced by the other rotor spinning counter clockwise. So the counter clockwise spinning rotor is slow) Tighten the screw that holds that rotor that is spinning more slowly. Use the screwdriver that came with the spare parts.
12/29/2013 10:25:15 PM •
JCPenney...
•
Answered
on Dec 29, 2013
•
1,088 views
My parents bought a Propel
I solved this same problem by removing the canopy and realigning the helix shaft with the motor gear. The small screwdriver provided will work. Be careful of the front white LED light when pulling the canopy off.
12/26/2011 10:43:59 PM •
JCPenney...
•
Answered
on Dec 26, 2011
•
3,071 views
The gyropter will not charge
Hi,
Check the charger adaptor if it has any output power. If no power comes out replace the adaptor.
Check also the battery terminal, it might already corrode and needs clean up.
If all does not work, the battery in the helicopter is already malfunctioning.
hope that helps you out!
12/7/2013 8:58:40 PM •
JCPenney...
•
Answered
on Dec 07, 2013
•
7,504 views
Gyropter not lifting off after full charge
Hi, Mostly all the micro copters problem are the battery and the the pinion gear that's been worn out.Check both of these part. Battery should at least gives out 350 mili amp. and the gear should touch the propeller shaft gear at the bottom of the copter.Get a lithium ion battery for more power and longetivity.Hope that helps!
12/5/2013 11:06:05 PM •
JCPenney...
•
Answered
on Dec 05, 2013
•
3,419 views
Not finding what you are looking for?