20 Most Recent
Konica Minolta magicolor 2400 Laser Printer - Page 2 Questions & Answers
Konica Magicolor2400W printer
check the tray is inserted correctly. I picked ours up once and it pushed the paper feed tray up to high. It cause this exact problem.
Printer won't print until I restart my computer.
After you have this problem again. Go to Control panel and look for administrative tools. Click on services and scroll down until you see the print spooler service.. Right click on this and select restart. Let me know if the printer then functions after this.
Page misfeed
There are 3 solenoids that can cause this. Two of them are easy to get to and the third is in the back behind the circuit board. Here is a link that will show you how to fix it. There is one under the fan.https://www.youtube.com/watch?v=4n7cIiyrk_Y
How to clean the feed roller
Here is a link to youtube to show you how to fix it.https://www.youtube.com/watch?v=MzWUFSEkoZEHope this helps someone.
Text is printing too low on the page
I have a Magicolor 2400w and had the same problem... I hope I'm not to late because I almost put mine in the trash.How I fixed the problem was I adjusted the solenoid behind the fan on the right side. I made a video and posted is on YouTube. Search YouTube for Magicolor 2400w paper size error. or follow the link.
http://www.youtube.com/watch?v=jlyuPJW6RjUHope this helps
Konica Minolta 2400W shadowy/smeary printing
check the two levers with an envelope on each, to the left and right of the
fusing unit, should be pressed down and not rise up.
Reset your Toners and Imaging units for Bizhub and CF series.
http://www.chipreset.eu
How to reset the toner counter chip?
There is
a small pcb on the cartridge contains a serial chip that counts.it can't be reset. Minolta probably calls it a MONEY chip as it forces u to replace the cartridge before u need to. u can buy new pcbs and replace it but it is probably not worth it unless u refill ur own.
Can not find a driver that works with windows 7
Hi there you could install the windows disk that came with the printer then plug in the usb cord with printer on and pc windows should find the drivers that is installed it did take some time to get mine right now works fine
I just replaced the C, M, Y toner cartridges and
Welcome to FixYa.
- Check if the paper is loaded properly and the paper guide is fitted with the paper.
- Clean the media feed rollers by wiping them with a soft, dry cloth.
Here's how to do it:
After cleaning the rollers, put back the drum cartridge. Make sure it is properly installed then close the printer properly. Then print a test page again.
Keep me posted.
Jas247
14h error
14: 2nd image transfer pressure/retraction failure
Relevant Electrical Parts
Retraction Position Sensor /2nd Image Transfer
(PC5)
Pressure/Retraction Solenoid /2nd Image Transfer
(SL4)
open cover, remove image transfer unit, behind ITU is 2nd image transfer roller, move it with hand, check solenoid and sensors, thaht they moving freely.
restart
good luck
Not finding what you are looking for?