20 Most Recent Kenmore 43142 Front Load Washer - Page 4 Questions & Answers

Either one of your water valves isn't working properly, or the lines have sediment restricting the volume of water . What I would do is turn the water to the machine off and remove the water lines and make sure they aren't filled will calcium, etc. and look in the water valves where the hoses connect because that are, which has a screen, may be full of nastiness. If both those are good then the water valve solenoid(s) are stuck and won't open. The humming sound you hear lets you know the rest of the machine is working because the sound is generated by power being applied to the valve by the control. If you need further help, I’m available over the phone at https://www.6ya.com/expert/jason_4570d45317834dd3

What is the model number of your unit?

take the front bottom panel off. inside there is a drain pump. you need to remove filter from drain pump its look like a knob. be careful because their is water inside your drain pump so use some big thing for water. clean your filter. put filter back tight. i hope will solve your problem.

Hello & Welcome to FixYa

This is a drain error in your Kenmore washer, if the unit is unable to drain it behaves like this. The first thing that should be done is cleaning the drain hose and the drain pump filter, you can take out three torx screws from the bottom front panel and then clean the area completely, lift up the cap to clean the filter. If the problem returns then check the drain pump if it is not working then replacing the pump is recommended repair, if the smell remains then you are correct the problem can be with the belt that needs replacement. Please get back to me if you have any other questions.

Kevin

Probably only needs a pump filter cleaning

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Since the door lock/switch assembly has been replaced yet the problem persists, the problem, therefore, is either with the wire harness connecting the assembly to the central control unit (CCU) or the CCU itself. Check and make sure the door strike, the one that activates the door switch, in intact and tightly installed.

Check the wire harness connection between the door lock/switch assembly and the CCU. Make sure the connectors are clean and snugly fitted both on the door lock/switch assembly side and the CCU side and that the wires are intact. Replace the wire harness if anything unusual for a good connector is found such as spark marks or corrosion. This is the simplest and best way to verify the condition of the CCU. If both the door lock/switch assembly and the wire harness are replaced but the problem persists, consider a faulty CCU that needs replacing.

this will more likely be your door seal open the door pull your seal so u can see inside and feel around as u look u will more than likely find a hole the water looks like it comes from somewhere else but it will be from the hole in the door seal seen this with hundreds of washers m8

Hi from retired Englishman in SW France,

That sort of information should be found in the manual and/or on the manufacturer's plate probably on the back. You could also try the manufacturer's/ Vendor's web sites ;-0)

If you need a manual you will need to type into your search engine/web browser '(make model number) washer manual' and you should be presented with a number of sources from which you can either download for free or have to pay a nominal amount.
You could also try the manufacturer's web site direct for that as well ;-0)

If this has assisted and/or clarified the situation for you please consider a 4 thumbs up on our rating.
Thanks and good luck!
John C

Hi,

Problems with a washing machine not spinning or not draining are often interrelated..

If you are having a problem with your top load washer then check out thistip...

Washing Machine does not Pump or Spin


If you are having problems with your front load washing machine then checkoutthis tip...

Front Load Washing machine not draining and or not spinning


heatman101

[
\[] \