20 Most Recent
Kenmore 24032\24036 Top Load Washer - Page 7 Questions & Answers
Control panel removing
you need to get a putty knife and slide it under the control panel,there are two clips that hold it down,one on the right side and one on the left side.watch this video and what are you fixing if you don't mind me asking if i can be of any other help let me know.
https://www.youtube.com/watch?v=j8_TzloPCwY
6/27/2014 10:20:01 PM •
Kenmore...
•
Answered
on Jun 27, 2014
How do you install belt
usually direct drive if top load,no belt has a motor coupling,send model number so i can look up your model,sears kenmore doesn't make washers,they just put the name on it,say washer starts with 110. on model,then you know whirlpool made it.
6/27/2014 12:34:35 AM •
Kenmore...
•
Answered
on Jun 27, 2014
How do you take the agitator out
take the top fabric softener cap off,you'll see a plastic cover down inside,pull that out,remove the 7/16 inch screw out,now you can take the top section off to change the dogs or reach down,grab the bottom of the agitator buy putting your fingers under it and pull up and keep you head to the side or you can hit yourself in the face when it pops off,saw someone do this
6/27/2014 12:31:14 AM •
Kenmore...
•
Answered
on Jun 27, 2014
Kenmore spin no t work
check the lid switch,open and close the lid,you should hear a clicking sound,if not you have a broken lid switch and the washer will sit there full of water
6/27/2014 12:24:38 AM •
Kenmore...
•
Answered
on Jun 27, 2014
How do i change door switch
Replacing the lid switch is not complicated, but you must take care in removing the console.
First slide a putty knife between the console and the top on both the left and right side. What you are trying to do is push a metal clip back so that the console can be lifted from the front and tilted up. This is the part to be careful so that you don't bread the plastic clips in the back.
After you have the console up, disconnect the lid switch harness to the top and there are two metal clips holding the top to the back panel. With a flat-head screw driver remove the clips.
The entire cabinet is ready to be lifted off the chassis. Just lift and pull forward to remove cabinet. You then can replace the lid switch. Just re-assemble in the reverse order.
good luck
6/24/2014 9:26:03 PM •
Kenmore...
•
Answered
on Jun 24, 2014
Kenmore 800 washer agitates before filling with water
This could be caused by a couple of problems. The water level sensor could be bad so that the washer thinks it's got water in it already or the timer could be bad. If the washer starts to fill after it starts agitating then the timer would be the problem.
5/30/2014 2:51:35 PM •
Kenmore...
•
Answered
on May 30, 2014
Top loading Kenmore h e washer roars while spinning
kind of hard to solve without more info.but it could be unlevel find a level or borrow one and place on top of washer.make sure it reads between bubble on level.check both sides on top of washer.if you hear kind of grinding noises and shifts hard it could be transmission..
5/29/2014 11:05:26 PM •
Kenmore...
•
Answered
on May 29, 2014
Not finding what you are looking for?