20 Most Recent Bosch WFLI 2440 Front Load Washer - Page 6 Questions & Answers

Slide a couple of sheet of newspaper under the machine and leave it a while and pull it out. The drips will show the approximate location. Then you can pull the machine out and lean it against the wall to check underneath. Make sure someone is steadying it. The most likely is a faulty water inlet solenoid valve.

I have never heard this before, but worth a try Resetting your washing machine

• First, you should perform a general reset of the machine. Turn the machine off at the power outlet, wait for one minute, and then turn it back on.
• If you see no change, you can try a Master Reset. This will reset all of the onboard componentry and is often successfully used by appliance technicians. Open and close the door of the washing machine 6 times within 12 seconds. Then, run the rinse/spin cycle without clothing to see if your problems are resolved. If it drains, problem solved!

• Nothing in the manual
• https://media3.bosch-home.com/Documents/9001346934_B.pdf

https://www.hunker.com/13410561/how-to-reset-a-bosch-washer

possibly a bad control board .

Pull them

https://www.manualslib.com/manual/1916755/Bosch-Professional-Al-1820-Cv.html

On some Bosch models, E00 indicates that the machine is overloaded. Alternatively, the load is too heavy when wet. The machine can't safely spin the load. You may need to take this blanket to a laundry mat and use their commercial size washer. Try running the washer when empty. If the error recurs, then the problem isn't the blanket. Instead, the motor is working too hard to spin the tub. This could indicate a problem with the motor or the pulley and hub that connect the tub to the motor. I wish that I had better news for you. Cindy Wells

BAD CONTROL BOARD??

If your washing machine makes a loud rumbling or repetitive banging sound, which is particularly bad on a spin cycle, then it is most likely due to loose or worn out drum bearings.

Did you read the manual ?

https://iinjaz-alkhalj.com/

so order replacement or notify repair shop

If there is an f57 error code, in 80% of cases the problem is related to the motor control board. But do not rush to buy a new one for your Bosch washing machine. When you solder the components of the board, they may be damaged as a result of the strong vibrations of the machine. Therefore, you need to monitor the correct and stable installation of your washer. In many cases, an experienced master can bring the device back to life. It will significantly save your budget. Think before you start an independent repair. Remember that the new electronic unit is quite expensive.

POSSIBLY IT HAS A BAD CONTROL BOARD .

BAD CONTROL BOARD

It is a good machine and still has life. The most likely cause is loose or broken damper springs. You would need to remove the top to check. If it feels loose at the back, (the front of the drum moves up and down), it is likely the rear bearing. https://www.google.com/search?q=Bosch+wkm41+parts ..

Time to get an engineer to fit a new heating element.

POSSIBLY THE CONTROL BOARD HAS A PROBLEM

What does the F43 blunder mean in Bosch clothes washer? It shows that the engine doesn't turn or something blocks the drum.

If your washer isn't spinning properly , it could be because of an unbalanced load, which makes it harder for the drum to spin. An unblanced load also cause errors. "Ub" or "Ur" display is one of the sign that your washer is unbalanced. This may be because the washer is lopsided or because the load inside is uneven.

Damaged or defective door lock