... Started it up and the resalts was the same. Can it be the coil or the pick-ups? The problem is the carbs. Is there any water in the gas? Remove the water trap bowl at the bottom of the petcock, (gas ...
Question about kawasaki ZZR 400 Motorcycles
What are the factory settings for the carbs on a ZZR400. I am having trouble getting the bike to run/idle properly. Generally all carbs from the factory have a mixture screw setting of between 1 1/4 ...
What are the factory settings for the carbs on a ZZR400N. I am having trouble getting the bike to run/idle properly. float height 13mm +/- 2mmpilot 35main jet size 100+102idle screw 2.25 turns from ...
Question about kawasaki ZZR 400 Motorcycles
Cannot start not using the choke and rpm flattens at 4000 rpm I have a 1997 Kawasaki ZR 400. Previously when I used to ride it I noticed that RPM flattens at 3500 rpm for a few seconds and ramps up ...
Question about kawasaki ZZR 400 Motorcycles
my ZZR 400 has no power. I've replaced the jets . my ZZR 400 has no power. I've replaced the jets . Carbs are fine Replaced spark plugs Struggle to idle in 3rd geare - loose power , can't go faster ...
...i can assume anything else,just a couple test u need to try out,, make sure fuel is getting in carbs ,,just undo carb drain screw and check fuel is in the carbs ,, just to iliminate 1 thing,, ...
CARBURATOR KIT My Kawazaki ZZR400cc model 2002 has a very low pick up at the start, for example when its stops at the signal and afete gearing , so the mechanic says its the problem of carberator and ...
Question about kawasaki ZZR 400 Motorcycles
...OF My ZZR 400 N, where does this go back into the carb and can i replace this without removing the carbs? please advise ta yes this can be replace without removing the carbs and it goes at the rear ...
Question about kawasaki ZZR 400 Motorcycles
...that gets ran down out of the way and doesn't connect to anything. If you are talking about the carbs then one goes to tank and one goes to the ...
Howto sync carbs on kawasaki zzr400 best way is to remove the carbs ! get 4 x 4mm drill bits , set carbs on a wide tickover gap on butterflies until you can get the drill bits in the gaps and adjust ...
5 questions posted
Usually answered in minutes!
17 Questions
17 Questions
16 Questions
9 Questions
5 Questions