2002 KTM LC4 625 Sc "compression" Questions

...for a night,i can kickstart the bike,but after that it acts like there is no spark.i have good compression and a new carburator. You're coil may be on it's way out and may need to be replaced. ...

WR 450F 2007engine oil and some compression coming out of engine breather to air filter compartment. engine has compression, decompressor engine turns over the same with the decompressor Engine oil ...

...is compressing at 110 and the remainder at 92 Squirt oil in your cylinders and recheck the compression. If your compression goes up you have bad rings. Check your valve tolerances to make ...

2000 Honda CR250R. It will not run and is low compression. I have completely rebuilt this engine, all new parts except for the top end, bottom end, compression is good done leak down test but top end ...

I have a 2002 HD 1200 Custom Sportster and I have lost compression in both cyclinders at the same time. Rode the bike and it ran fine. 2 weeks later I got on the bike and started it up and one cyclind

The bike starts great but doesn't hold an idle. Check the compression. Both cylinders should each be able to produce at least 140PSI of compression. If the compression is low, make sure the valve lash

need compression range for 2001 KTM 125 need compression range. Put compression gauge on bike getting 145psi. buddy this is fine brilliant compression there ment to be from 100-185psi tops if below ...

what should be the compresion spec for a 2000 FLH Thanks To test the compression of the engine, use a good screw in type compression gauge. Hold the throttle wide open and rotate the engine through ...

it would just change the swingarm location to me. Any clearance issues with the rear fender on full compression? Would it balance OK with the front if travel there is reduced to 10 or so?I have an '02

the bike wont start! seems to have good compression, and fire. the timimg mark is lining up at tdc but with a shot of starting fluid i have gotten a flame thru the carb! oh, and the valves have been ...