Konica Minolta bizhub 350 All-In-One Laser Printer "side door wont open" Questions

...side door wont open. The release lever won't open door. Is there a way to take the door apart to get to the release lever. yes the right side of the door on the bottom there is a spring loaded hinge ...

Side Door or their is a door on the rear make sure that isn't open. What I would do is Physically open and re-close all doors again the tabs and sensor get sticky after awhile. If not you could have a

...side of the door. This tab is supposed to go through a small slot in the cover that would then contact the door sensor/switch to tell the machine that the door is closed. If you located the little ...

...door close and opens there is a sensor or it could be a switch to let it know when it closed or open so have a look at that side of things see if it is sticking ar it need a clean. Please come back ...

...side of the door disengages the toner and when that doesn't pull freely the gear inside is broken and a shop needs to replace for you. If just the toner, you press the blue lever and lift the toner ...

Door 1 Open the ... side to locate a green lever. Note: To clear the Paper Jam error message, you must remove ... above Tray 1 when the duplex function is in use. To clear this type of jam, follow the

Back cover open, wont print, scan or copy. All covers must be closed before the unit will operate. Double check that the back door is closed completely and latched on both sides.

main body. It also will only allow one drawer to be open at a time. There is a manual release lever on the left side of each drawer. The lever is accessible by opening the long, skinny left front door

...door is opened the power is shut so...). Cut a piece of plastic just the width of the opening, fold it at angle in the form or an L, then place it on the left side of the opening, so that the shutter ...

... and left side of toner unit thr is a sensor door, behind that door there is also a light sensor bulb, which needs cleaning by a cotton bud. thats all i hope this will help u fixing that problem. ...