Bosch WET 2820 Front Load Washer / Dryer "pcb" Questions

E90 IS THE ERROR CODE IT IS SHOWING E90 is a communication error between the main pcb and the display pcb.Check the blue wiring loom that goes from the main pcb to the display pcb.normally it is a bad

...with water fill during washing -Tap closed; solenoid valve, water distributor, wiring ,main PCB, pressure switches E01(E00)- Problems with water fill during drying -Tap closed; solenoid

...it counts at 30 gets down to 28 again and does the same dr code again Your problem lies in the PCB assembly, or pump motor, most likely the PCB assembly. 1. open lid 2. remove control panel

WHATS A PCB? TRYING TO IDENTIFY PART TO REPLACE PCB MENTIONED AND DON'T KNOW WHAT THIS IS THANKS pcb is a power control board pcb is main board to machine controls everything can be expensive ...

toshiba washing machine aw-sd160s E 71 Please replace the PCB .There are two PCB. If you can repair second PCB the issue is in second PCB replace IC 2903d.

...error code of EWF1282 FRONT LOADER ELECTROLUX WASING MACHINE E9F - Communication error between main PCB and Inverter board. Could be: Faulty wiring between main PCB and Inverter; Inverter PCB faulty; ...

le code Repairman states that the main pcb or the wired plug is to blame. Change pcb first and then harness if problem persists. Quite expensive for both since i just changed the pcb for the motor. Is

...display on Beko washing machine WM 741135w. all fuses etc checked, 240 volt supply to rear of main pcb, has the main pcb blown ? checked all mains supplies, all present at 240v ac, 240 v preant at ...

machine wont start after replacing blown pcb module Pcb module is shot and has been replaced are there any other associated problems ,all control lights are lit ,but when its set and turned on it ...

I NEED PCB BOARD FOR HOTPOINT WF865 WASHING MACHINE I have checked the Hotpoint web site, and a pcb is £114.00. You also need the eprom which plugs into the pcb,this is another £24.00, and is ...