Question about Kenmore HE2 Washing Machines
drain pump problem and/or clog in the drain line. You will need to check the following: 1.First, attempt to unplug the washer for at LEAST 30 minutes to reset the Central Control Unit (CCU). Sometimes
...drain pump. This tip i wrote explains how to take apart the washer and clean the filter on the pump. http://www.fixya.com/support/r10121384-check_when_duet_washer_door_locked_after If you find the ...
Question about Kenmore HE2 Washing Machines
...apart and found that rubber bands had worked their way in. The motor is fairly easy to disasseble and reasemble if you pay attention to where each part comes from(the motor housing has a plastic stop ...
Question about Kenmore HE2 Washing Machines
drain and you would have gotten a F-28 error code. If it is in the back. . .heaven help you. It can be reached but it is such a pain in the neck to tear it all apart you would loose your mind. Promise
...apart in order to snap it back into place. It would be advisable to use a second set of hands to hold the wire hoop in place while doing this as it has the tendency to want to come out of the groove. ...
Question about Kenmore HE2 Washing Machines
...apart? I cleaned out the drain plug- full of sand, filter clean, but I can't see the actual drain pump to see if something might be Can I get to the drain pump or does the washer need to be torn ...
...drain pump you need to undo three screws holding it to the filter and when you pull it apart your problem will fall out ( normally coins or bobby pins or nails if not take the hoses off as well and ...
drain pump and the adjacent filter. Have a bucket handy to catch the water from the pump. Open the filter and remove any foreign objects. Look into the pump and check for any objects that got past the
...drain out...the door lock is tied into the pump and until the pump tells the control board that the wate r is out the door will not unlock. This tip i wrote will show ya how to take apart the washer ...
...drain is clear. i took the pump out . then took the pump apart , water got past the o ring , where shaft goes into the center. i cleaned out the sludge & put grease on the o rings before putting it ...
2,986 questions posted
Usually answered in minutes!
11 Questions
12 Questions