Zongshen Motorcycles - Recent Questions, Troubleshooting & Support

Oil seal on the crankshaft has failed. Replace the oil seal.

What is the question?

manualslib.com

No, not with out some major fabricating.

Go online for the nearest dealer and see what he's got. These are cheap imports with very little support so you could have trouble.

You can buy this http://www.haynes.com/autorepairmanuals/zongshen/zs125gy-a Haynes Zongshen ZS125GY Repair Manuals and/or check the local library for one and also, contact Zongshen via email: [email protected] I just did for you in fact. http://en.zongshenmotor.com/?q=node/524 you can also join and post ina forum or some user group like:

if you have the gasket set just match up the gaskets you take off if your set has one too many it could be for different model but same engine with higher or lower performance.

if you have replaced all that it sounds like it is the stator. its an alternator for small engines. get one on ebay cause factory are always expensive. its located behind the pull start. take that off then the side case cover.

Alot of times if you look and the base of the cylinder there will be a Cm #. That number is the cc's of the bike. for example if it says cm250. Then it's a 250. and so forth. I’m happy to assist further over the phone at https://www.6ya.com/expert/robert_5bac37c3cb991fdb

bad earth connection on engine to frame

Okay??.....and.....???