Vuka Motorcycles - Page 4 - Recent Questions, Troubleshooting & Support
The headlights are dim on one side on my chevy pickup
Make sure you have the rite bulb, check you voltage level at the pigtail and compare to the other side if those are fine check you ground wires if voltage is low inspect power wires for corosion or broken wires Also check the resistance if no obvious damage to wire but resistance is high the wire should be replaced
Vuka XL 110 What is correct setting for air mixture screw on carburetor?
wined the air mixture screw all the way in and then 2 and a half turns out then start the bike if it will let you (no choke) if it wont start turn another .5 turn until it will start.Once you get it started leave it running at idle and listen to the engine noise very carefully. give it a rev and even a ride if it stalls wined it out .25 of a turn.
Hi I need the valve
vuka rm125 has no timming chain it is a pushrod engin you should adjust the vaves cold at0.10mm
Were do the fuel lines go to on a mountop 150cc
This particular unit has a typical GY6-style engine with a fuel line designated from the gas tank to the carburetor distinguished by an in-line cylindrical fuel filter located near the center of the line. Best to locate the carburetor distinguished by the location of the air filter, there should be a hose going from that unit up into the gas tank.
Ideally, remove the gas tank entirely and it should reveal the gasoline lines directly to the carburetor.
The photo shows the fuel line/filter indicated in red, and the location of the carburetor within the blue indicator.
2/28/2024 4:42:51 PM •
Motorcycles
•
Answered
on Feb 28, 2024
Cleaned my carburetors and the Jets and now my bike won't start. I have a spark but it won't start.
All questions need FULL 'year make model', as the first 3 words.
Then there are 10,000 categories listed by 'make year model'.
So we are working blind.
Make sure gasoline is being delivered to the carbs by removing the fuel delivery pipe.
Carbs come in different systems. If it has a float bowl on the bottom, tap it with the handle of a screwdriver as it may be stuck.
Turn the engine over. If it doesn't start, remove the spark plug and see if it is wet with gas?
You need three things for an engine to start
Clean gas
A spark at the right time
Compression
You have one thing missing
//
2/21/2024 6:59:48 PM •
Motorcycles
•
Answered
on Feb 21, 2024
Not finding what you are looking for?