I need to find engine number and vin number for regista=ration and i have no papers

Should be a tag on the differential under one of the cover bolts that has that info on it. Otherwise you will have to take cover off and the ring gear will have the ration stamped on it on the edge... You could also count the teeth on the ring and pinion, divide the ring gear count by the pinion gear count.

Hi Don:
Vin number should be on dash in front of steering wheel. read from outside. Sould also be on tag on drivers door jamb, and on registration papers.

Get the VIN number from your registration. Contact a dealer for your car model (Honda, Toyota) and ask them. They can tell you what engine it is. No mechanic would need the actual engine serial number.

All integers are rational numbers. The easiest way to see that is to write an integer as a fraction with 1 as a denominator; 4=4/1=8/2; 5=5/1.
Any number that can be written as a ratio of two integers numbers is by definition a rational number ( it is a ratio---rational).
Any decimal number with a periodic decimal part can be cast as a fraction, so it is rational.
An irrational number is a number that cannot be written as a fraction.
Examples: PI, sqRT(2), Sqrt(3), SQRT(5), e. There is an infinite number of them.

Yes it is. You can obtain this value by dividing one integer by another, 55/2

A rational number is a number that can be expressed as the RATIO (see rational) of two integer (whole) numbers. 8 is an integer, and so is 3. The number 8/3 is a RATIO of two integers :it fits the definition of a rational number.

There are an infinite number of rational numbers between any two rational numbers.

Given any two rational numbers, the number midway between them is also rational. By the same logic, the number midway between the smaller of the two original numbers and the midpoint is also rational. And so is the number midway between the first number and the second midpoint. And so is the number midway between the first number and third midpoint... and so on.

you have a paper sticker in the trunk(boot)with the KW output for the engine that would be better.but why do you ask, then not include them in your question??????

WELL I SEE TWO DIFFERENT 2.0 ENGINES ONE IS VIN P THE OTHER IS VIN 3. BUT THE FIRING ORDER IS THE SAME 1 3 4 2 .STANDING IN FRONT OF VECHICLE LEFT TO RIGHT. 1 2 3 4. THAT THE CYLINDERS ORDER.NOW I AM LOOKING AT 2 DIFFERENT SET UP FOR PLUGS WIRES ON COIL PACK.GET A SHEET OF PAPER. WRITE THESE FOUR NUMBER DOWN.THAT WILL BE PLUG NUMBER TO THAT CYLINDER.TAKE A PIECE OF PAPER WRITE NUMBER 3 UPPER LEFT 4 BOTTOM LEFT 2 UPPER RIGHT 1 LOWER LEFT.HOLDING PIECE PAPERSTANDING IN FRONT OF ENGINE THIS IS YOUR PLUG WIRES TO COILS THEN YOU MATCH THEM TO THE CYLINDER NUMBERS.THAT WAS THE 2.0 VIN P ENGINE.NOW FOR THE VIN 3 ENGINE.TAKE ANOTHER PIECE OF PAPER WRITE NUMBERS DOWN. NUMBER 1 UPPER LEFT 4 BOTTOM LEFT 3 UPPER RIGHT 2 BOTTOM RIGHT.STANDING IN FRONT OF VECHICLE MATCH NUMBERS FROM BOTH PAPERS TO COILS THEN TO THE CYLINDERS .THIS SHOULD GET YOU BACK ON TRACK.LET ME KNOW IF YOU HAVE TROUBLE.

To avoid confusion, remove and tag the spark plug wires one at a time, for replacement.

The 3.5L (VIN H) engine's unique ignition system has the ignition coils directly over each plug. No spark plug wires are used.
If a coil is replaced on any of the 3.1L, 3.4L or 3.8L engines, it may not be numbered, as is the factory coil. For this reason it is imperative that you label all wires before disconnecting any of them. Also, before removal, compare the current wiring with the accompanying illustrations. If the current wiring does not match, make notes in your guide to reflect how your engine is wired.



Fig. 3.1L (VIN M) engine Firing order: 1-2-3-4-5-6 Distributorless Ignition System



Fig. 3.4L (VIN X) engine Firing order: 1-2-3-4-5-6 Distributorless Ignition System



Fig. 3.4L (VIN E) engine Firing order: 1-2-3-4-5-6 Distributorless Ignition System



Fig. 3.5L (VIN H) engine Firing order: 1-2-3-4-5-6 Distributorless Ignition System



Fig. 3.8L (VIN 1) engine Firing order: 1-6-5-4-3-2 Distributorless Ignition System



Fig. 3.8L (VIN K) engine Firing order: 1-6-5-4-3-2 Distributorless Ignition System

The firing order for the 3.1L VIN M, 3.4L VIN E, 3.4L VIN X and 3.5L VIN H engines is 1-2-3-4-5-6. The right bank cylinders are on the cowl side (rear) of the engine compartment and are numbered 1,3,5, left bank cylinders on the front side of the vehicle, are numbered 2,4,6.
The firing order for the 3.8L VIN K and 3.8L VIN 1 engines is 1-6-5-4-3-2. Starting at the front of the engine, cylinders in the left bank are numbered 1,3,5 and cylinders in the right bank are numbered 2,4,6

Hope helped (remember rated this help) Good luck.