SOURCE: Play in rear wheel
bearing end play is .002''-.006'' this is done by inner spacer shims. sealed bearings can be installed instead of timkin and they are practicaly maintenance free
SOURCE: rear wheel spacer placement?
Take great care on reassembly ,as the spacers may be of diffrent lenghts which will if put back wrongly will throw the wheel off its true running centre .and cause problems .Allway remember to mark parts or do a drawing when removing and stripping down for repair or servicing ..It saves a great deal of problems .Try and assemble the spacers and look to see if the wheel is in line with the belt drives .
SOURCE: what is the sequence of putting spacers on rear
Not much on newer hogs but I'd guess if the spacers aren't the same length when you got the wheel on you'd see that the wheel isn't centered.Try again.Put the end thru the swing arm put on a spacer,push it thru the hub,put on the other spacer,push it thru swing arm put on washers and nut[loosely]and check the alaignment.Like I said I'm not much.
Testimonial: "Your suggestion was very helpful. Thanks! "
SOURCE: i need to know rear wheel spacer placement. also
The wheel not being equally spaced under the fender is typical of all Softail motorcycles. They have an "offset" wheel stance. I don't know exactly why but they are designed this way.
The three spacers you are talking about is actually one spacer and two seal races. The two seal races go into the wheel bearing seals on either side of the wheel. This provides a smooth finish for the wheel bearing seals to ride on. The other "spacer" is a bit larger and goes on the belt side of the wheel and the rear brake caliper bracket acts as the spacer on the other side. Anytime you take the wheels off your bike, always mark and make a drawing of the positions of the spacers.
Good Luck
Steve
SOURCE: Hello, I have a 99
Sounds like you've got it together correctly. There is no washer between the brake caliper bracket and the swingarm. You can put the axle in from either direction. We usually put them in from the left side so that we no longer have to remove a muffler to remove the rear wheel. The nut is now on that side. Just make sure the wheel turns smoothly and the brakes work correctly before taking in out on the road. If you hear a chirping noise when you shift gears, your rear belt is too loose.
Good luck
Steve
544 views
Usually answered in minutes!
×