How do you jump starter on a 2000 Electra glide @
Hi, Tom, the best way to jump-start your bike is to use a jumper battery and cables, if available, before trying to push start:
1. Your battery connections must be clean and tight.
2. Jumper cables should have 8 or 6 gauge wire.
3. Only use a known good fully charged jumper battery.
4. When jumping from an automobile the engine "MUST" be off.
5. Connect the positive cable first.
6. Let the bike battery charge for 1 minute before starting.
7. Once the bike has started, remove the negative cable first.
8. If no battery is available you can try to push start.
9. Always look for a downhill slope if available.
10. Shift into 2nd gear clutch in and have someone push you then stand up on the footpegs and slam your buttocks into the seat exactly at the same time let the clutch lever out.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below and for more specific information or questions at no charge please feel free to contact me at [email protected]. Good luck and have a wonderful day.
https://www.youtube.com/watch?v=61sNSoiI_JI
http://www.mediafire.com/file/a9pvi3kbxhkfla2/2000+Harley+Davidson+Touring+Models+Service+Manual.pdf
https://partsfinder.onlinemicrofiche.com/ronnies/showmodel.asp?make=hdmc
https://serviceinfo.harley-davidson.com/sip/service/document/6300?highlight=1998+sportster+owner
https://www.6ya.com/
SOURCE: air in rear shocks
Depending on your weight and if you carry a passenger as to the air pressure. I normally run about 14 but 24 if riding 2 up.
Recommended pressures:
up to 150 lbs- 0
each addition 25 rider pounds > 150 lbs add 1.0 lbs
each additional passenger pounds > 150 lbs add 1.5 lbs
each additional 10 lbs of laggage add 3.0 lbs
Max Pressure 35 psi
SOURCE: I need touch up paint for my 2000 electra glide
2000
Aztec Orange Pearlcoat 61889
Birch White 90303
Bronze Pearl 62074
Chrome Yellow 84454
Cobalt Blue Pearlcoat 191058
Diamond Ice Pearlcoat 37056
Ice White 92151
Luxury Rich Red 75946
Sinister Blue Pearl 190524
Suede Green Pearl 400442
Viking Purple/Concord Purple Pearl 52788
Vivid Black 9850
White Hightlight Pearl 92151/92152
SOURCE: RACING IDLE
you may have to take it to the dealer and have them hook it up to the computer im a harley tech and usally when that happens its the tps sensor getting a false readind bc of an insufficent mapping due to adding on pipes filter or power commanders etc.they may have to get you a new tps sensor or may be able to give you another stock recalibration for the ecm due to the weather
SOURCE: I keep blowing the accessory fuse on my electra glide
I'd say that you have an intermittant short somewhere. These are very difficult to find. I'd start at the tail light assembly as most of the time, I've found the shorts in that area, from the seat back to the tail light assembly.
Good Luck
Steve
312 views
Usually answered in minutes!
×