You can check if there is a oil seal broken on the right side of the engine. The engine uses the oil from the engine. Was there less oil in the engine before. I think its a morini engine.
The same as the Rieju here is a picture of it.
https://www.oemmotorparts.com/oem5.asp?M=Rieju&T=%20MORINI%20%2050%20ENGINE&Y=.&L=RE-MORINI_Motor9&O=MOTOR&F=RE-MRN_MOTOR9&L2=RE-MRN_MOTOR9_MOTOR
Took me a min or two of WTF-ing to see pic and realize you meant a 2-stroke motorcycle..
SOURCE: Removal of oil pan?
The car has three mounts in a triangle configuration. The front trans mount, the passenger side motor mount and the rear motor mount. I do not know if anyone has ever successfully raised the engine to slide the pan out, but remember, if you do this, the pan goes back on with anaerobic gasket maker on it, so make sure you can slide it out with grating on the underside of the block. If you can't, then it will likely be impossible to get back in place without smearing the gasket maker all over and making a heck of a mess. The commonly accepted way to remove the pan is to remove the two front subframe bolts and allow the subframe to drop enough to get the clearance you require. The bolts are 18 mm heads and are really torqued on there so you will need a serious breaker bar and cheater bar to go with it. USE SOLID JACKSTANDS or BETTER YET, RAMPS to do this. The force you will need to apply can take the car right off a single jack.
SOURCE: i like to change my own oil in my 954. over the 8
I HAVENT CRANKED MY BIKE IN ABOUT A YEAR, IT NOW WONT START AND I THINK ITS BAD GAS HOW DO I DRAIN THE GAS AND CLEAN THE FUEL SYSTEM
SOURCE: my 2008 kx 65 is
Make sure the choke is fully disengaged while riding. Is it two stroke? If so, make sure fuel/oil mixture is not too rich. If four stroke, try a colder plug. If four stroke, make sure valves are adjusted properly.
SOURCE: I have a 49cc two stroke bike, (pit bike) like
Ok, a two stroke engine basicly needs 3 things to run: fuel, compression and ignition.
First, check that the fuelline, fuelfilter, or fueltap is not blocked. If the fuelflow is alright, check that the compression is fine. try kicking the kickstarter a few time: the should be a certain resistance.If the compression is wrong try changing the headgasket. If it is alright, check the ignition. This is done by taking the sparkplug out at placing it on the frame, when you kick the kickstarter a spark should jump from the sparkplug to the frame.
But my guess would be that you have a partly blocked fuelsystem.
109 views
Usually answered in minutes!
×