Need the tork setting fro a kawasaki 2008 ZZR 600

find your bike here then choose parts diagrams...

http://www.kawasaki.com/DefaultFrame.aspx?strContentUrl=/SITE/VIVEHICLEINFORMATION/VICHOOSEVEHICLE.ASP

Good luck, these are hard to find new or used. The 600's and up are available.
Have you checked with your dealer, they have access to all parts available nationwide through the computer? There might be one sitting on a shelf somewhere. You might be able to find one from someone that is parting out a bike also---like on ebay.

Which torque setting. For the clutch basket nut? The torque spec for the cover bolts?

I’m happy to help further over the phone at https://www.6ya.com/expert/al_e83b1941f9c0f302

Hello mine leaks out the two ram inlets on cards when I'm trying to start it it just flows out of the

1st would be adequate free play-No free play clutch is not fully engaged. 1/4 inch free play needed at clutch lever.

2nd would be oil type. Motor oil is a no no. Wet clutches hate regulat oi. Must use oil specific to the bike. Good luck

check your de-tenton spring and roller on the shift drum "star" behind the clutch basket. The worst case is that you shift forks could be bent or the under cut gears in your trany may be worn.
Let me know if you need help getting to backside of the clutch basket.
Mark
C.C. Motorsports

check your clutch adjustment.

yes , if you can remove the baffle, then remove some of the fiberglass wrapping re fit and see how it is, dont go too mad first off. as you may make it too noisy