SOURCE: Dyson DC01 - can't get starter button switch off.
this issue is known well with dysons to be honest you will continue to have this problem for as long as you have the vacuum. they use substandard plastic parts which break easy. You will have to replace the button and make sure there are no other broken pieces of plastic in the housing before putting it back together.
SOURCE: Starter problems
you need to check and see if you have 12volts at the relay and if you have 12volts at the wire from the switch on the relay. if you are getting power to the wire from the switch then you may have a bad starter relay.
SOURCE: my 1987 toyota pick up 5 spd will not start when
There will be a switch on the clutch pedal bar under the dash somewhere. When you push in the clutch the pedal touches the switch and completes the circuit. It may be out of adjustment, or just worn out. You can either replace it, or remove it, and pigtail the wires together. Although, if you do that, be aware that it will start in gear, clutch out, and could be a safety issue.
SOURCE: Attempted to start , pushed start button , engine
Ok, make sure your battery is installed and connected correctly. The connections should be clean and tight. Now, look at the end of your starter. You'll see a five sided plate with a tower like thing in the middle on the end of your starter. Just above it is a single wire that plugs onto the starter. Unplug this wire and insert a test light into the wire. Turn your ignition on and press the start button. If the light lights up, your starter is bad. If it doesn, you've got another problem.
If the light does not light up, you'll have to find the starter relay. Harley moves these things around all the time so you never know where to look for one from year to year. I'd start under the seat and then move to the side panels if necessary. The relay is a typical one inch cube made of plastic. When you find it, turn on the igntion and press the start button while holding the relay. It should click. If if doesn't, it's probably bad and even if it does, it's probably bad. I'd replace the part as it's not all that expensive.
If you suspect the starter, go back and remove the three screws that hold the five sided plate onto the starter. Behind the plate you see a plunger with a spring on it. NOW, MAKE SURE THE TRANSMISSION IS OUT OF GEAR. Using a large screwdriver, push the plunger into the starter as far as it will go. The starter should engage and turn the engine. If not, you may have to replace the large copper contacts in the solenoid.
I hope this helps you find and fix your problem
Ride Safe
Steve
SOURCE: kenmore 600 series dryer.model # 110.67622600.
Hi,
There can be many reasons why your dryer will not start or turn...
The most common causes are the belt breaking or jumping off, or the motor goingbad...
Here are a couple of tips that I wrote will help you to figure out why yourdryer will not run...
Dryer Repair - The Dryer is not Turning
Dryer Repair - The dryer will not start
heatman101
;';'
71 views
Usually answered in minutes!
×