The XT version ( which is registered for road use ) did come with a tool box - but the TT was unregistered for dirt / motocross use. Just want to know if the TT was sold with a tool box and tools same as the XT
Every motorcycle from Yamaha I have owned has a tool kit. It is usually located under the seat or under the battery.
Testimonial: "Thanks Steve. The XT had a tool box mounted almost under the rear LH blinker with a tool bag/pouch full of tools inside . I was told on another site that the TT did not have one ."
SOURCE: Need A Scan Tool To Tell ABS Computer To Bleed Brakes
WELL THERE IS A DIFFERANCE BETWEEN A SCAN TOOL AND A TOOL THAT IS CAPABLE OF OUTPUT CONTROLS SUCH AS THIS ONE A SCAN TOOL CAN BE BOUGHT FOR LITTLE MONEY ONE CAPABLE OF DOING WHAT YOU NEED TO DO IS MUCH MORE EXPENSIVE SNAP ON BRICK IS AN OLDER ONE WHICH WOULD WORK BUT EVEN THAT IS ABOUT $600 SO IT SUCKS BUT THE DEALER IS GONNA BE YOUR BEST BET HOPE THIS HELPS
SOURCE: I want to remove the magneto from a Yamaha xt350
Back the screw handle out so the end of the screw is inside the the large collar. Remove the nut and washer holding the flywheel on the crankshaft. Screw the puller collar fully into the flywheel. Now turn the screw handle inward to contact the end of the crankshaft. Tighten the handle down then strike the handle arm with a hammer for extra pressure on the screw. Next, strike the center of the screw with the hammer. Alternate strikes between the center screw and the screw handle. Do that until the flywheel pops free. Some pullers have flats for wrenches instead of a screw arm. The principle for removal is the same.
SOURCE: I can't register my new tool on WWW.BlackandDecker.com/Register.
The site is working for me... but it redirects to the following page anyway, so you might want to cut ans paste the following address into your web browser and go from there:
http://www.blackanddecker.com/MemberCenter/
SOURCE: serial number daemon tools 4.36.0309.0160
You can get free Daemon tools from :- www.brothersoft.com/downloads/daemon-tools.html
56 views
Usually answered in minutes!
×