I have a 2012 kymco 200i like, i changed the starter and coil so when i go to hit the the start button it just clicks any ideas ? Could it be the regulator rectifier ? Or the ignition ? Also put new battery and tried to start with jump but nothing stuck need help !!!

SOURCE: No power to ignition - ? please help! 91 amigo 2.3l

If everything is turning on, and there's power... check for 12V at the alternator. it may be out now.... or a connector came loose, or wire broke.

SOURCE: 2001 pt cruiser limited won't crank

needs a battery but be careful cause sometimes a bad alternater will cause the battery to go bad

SOURCE: 2003 honda 250cc atv starting problem

First i presume the engine is turning over when you hit the starter and the coil /module you replaced is a known good unit,check resistance on secondary side and make sure all earths ARE earthed.....First of all i'd check the pulse/trigger coil , it could be completely dead.that would be the black/yellow and green/white wires coming from the engine case,they should read around 125 ohms and have about 4 cranking volts,make sure the spark plug is ok too.then id check the timing and make sure that the flywheel key has'nt broken and it's just spinning on the shaft.Hope this can be useful to you CFI.....Tabbycat

SOURCE: Having starter or starting system problems

i would normally say check the bat. connections but since you tried jumping it off i will lean towards starter solenoid.

SOURCE: new starter new battery still wont start last

Very likely the new battery is defective - it happens. If you have a know good new battery, then also connect a jumper from the battery negative to the block just to be sure its not a defective or loose ground cable.