The turn- bank sensor may think you have wrecked or just tipped over the bike. It may need to be replaced. Have you had to lay it down lately? Usually they reset after being turned on again after a lay down. It might not be resetting. Good Luck with that one.
Thanks for reply, and nope I didn't lay it down , but good call, I'll check that sensor and give an update if that's the verdict
Tried to locate the sensor and read on forums but could not find anything on turn bank sensor on this monster. Any other ideas ?
I just looked on youtube and a discussion group, and there seems to be a lot of problems with the Ducati ECU and the IMMObilization feature. They could all be due to a "low" battery" condition but from here, it's impossible to tell. I would charge the battery at this point and be sure that it is FULLY charged. All computers require a certain voltage to function. I had a Corvette that would not start unless the battery was above 13 volts. If you eliminate that possibility, then I would call the dealer. Sorry for your troubles. Good luck
×
SOURCE: Turn key, nothing happens
It could be the park/neutral switch, next time it doesn't start try wiggling the shifter in park while turning the key, or shift to neutral and see if that will work. if that doesn't change the problem I would replace the ignition switch.
SOURCE: 2008 Toyota Tundra shuts off immediately after starting up
It sounds like you have a bad key-transponder ECU. It should still be under watrranty. This is a known problem, and a bulletin has been distruiibuted to address this issue.
SOURCE: ignition switch dont turn, I have two master keys,
ignition switch tumblers are worn and will have to replace the switch, which will come with new keys.
SOURCE: My monitor turns black automatically after about 3
LCD monitor? More than 2 years old? Basic LCD monitor and TV troubleshooting guide: Learn about bad caps: http://en.wikipedia.org/wiki/Capacitor_plague Capacitors kit: http://lcdalternatives.auctivacommerce.com/ he can make you a set of caps for you.
If yes, then read on:
Most common failures in the LCD monitors are bad capacitors (bulging top/seal or leaking) in the power supply (they should be replaced in a set), blown fuses; poor solder joints, failed inverter circuits (blown fuse, shorted transistors, shorted/open transformers), bad lamps (poor solder connections or worn out lamps). You will need to open it up and inspect the inside, see example of failed monitors to get some ideas what to look for: http://s807.photobucket.com/albums/yy352/budm/
Post back what you see inside so we can guide you further and it will help out other people in the future also.
http://www.fixya.com/support/r6150077-basic_lcd_monitors_troubleshooting
http://www.fixya.com/support/r5093881-lcd_flat_panel_tv_troubleshooting_guide
http://www.fixya.com/support/r7406380-tv_training_manuals
Failed TV and Monitors pictures: http://s807.photobucket.com/albums/yy352/budm/
Or www.digikey.com just make sure to use caps with low ESR, 105c, high ripple current, long life rating such as PANASONIC FM or FC series.
172 views
Usually answered in minutes!
×