Hello FixYa, what drive chain would the 2008 Honda CB 1300 S have been fitted with from the Honda Factory ? Mike Burger

SOURCE: fuel pump blew fuse twice within 20 miles but not since any clues

its either a short in the fuel pump wiring...or you got a pump going bad.

SOURCE: I have a 1968 Honda CB 450 engine, (it was in a

It will not go in without some serious reworking of the frame and mounts.

SOURCE: i have a brand new

You should take it back to where you purchased . They can fix it for you . If you let it get worse then it is now some of your digtal might become hard to read, It should be under warranty . I think
it will be quite easy to find the problem . It should not cost you this way. If you take it apart you
will have to fix it , because the dealer will charge you if he finds out that your were messed with it.

SOURCE: RE: DELL Inspiron 1300 Hello, Would a 14" screen

NO! it will fit in the opening but it will not have anything holding it in. So while yes it technically will "fit" it wont work as the screen will fall out every time you close it!

SOURCE: How easy is it to fit a cam chain and link in sit to a Honda CB 750 1994. and what is the main problem with a rattling chain on one?

eaasy take off the timing /rocker cover and the top chain guide exposing the top of the chain undoo locknut and back off tensioner then break chain after tying both ends with cord so they cant fall in then splice the new chain onto the old and wind it through taking care to not let it jump teeth on timing wheels, detatch old chain from the new one, swage rivet pin in join of new chain crank engine by hand with a spanner two full rotations to check for valve piston interference and reassemble tighten tensioner until chain feels tight then back off 1/4 turn put back upper chain guide and bolt down rocker cover and you are done easy