1991 Harley Davidson Fatboy speedo wire melted. I need to change the bulb in my speedo. The wire that mounts to the speedo case by a ring terminal melted Should I worry about any other items all lighting works will try to start today
SOURCE: 2007 Harley Fatboy Taillight problem.
Check to make sure BOTH light filaments are intact. Or try another bulb to double check the situation before wasting to much time on a simple fix.
SOURCE: picture wiring diagram for 2003 harley fatboy
May I suggest a trip to your local library. Cycle repair books should be in 646 stacks of reference.
Otherwise you can Google for 2003 Clymer Service manuals on the internet.
I think Clymer had electrical diagrams in their books. I doubt that any except the HD service book would have anything about the physical location of the harness, but the pictures in the other books would help you.
SOURCE: engine diagram for 88 cubic inch harley davidson
I was able to pull up the complete maintainence book with wiring diagram, parts assembly, torque specs and part numbers by just going to www.1972 flh 80 harley davidson oem.com
SOURCE: how to replace the fork seals on a 2003 harley
If you ask this question YOU should not be doing it! but your *** on the seat not mine.
Remove ...........front wheel, front fender,top fork cap and loosen lower triple clamp bolts under head light cover, forks are now out!
Remove 6mm bolt at the bottom of the fork leg and drain oil,remove dust seal and wire clip, now remove the upper fork nut (the spring will jump out at you).Pull the leg and tube away from each other, the old seal will stay on the tube..clean and reassemble driving NEW seal down into place with wire clip.....refill with oil
SOURCE: how to shut off and on harley davidson hazard
ignition on push both indicator buttons at once and hold for about 2 seconds or so
276 views
Usually answered in minutes!
×