- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Unhook the connection under the gas tank. Remove the pins from the elelectrical connection for the fuel gauge. Pull the gauge up. It is held in place with a piece of plastic that surrounds the gauge housing. Good luck!
Check for clogged jets. Also remove the air filter and look into the carb while working the throttle. You should see gas squirting into the carb from the accellator pump. If not, the accellator pump orifice is clogged. Also check the filter on top of the petcock inside the tank.
The oil drain us usually a hose with a plug in it that is held by a clip on the frame. It us usually on the right hand side of the bike just behind and underneath the transmission side cover. Loosen the clamp and pull the plug out. The oil will run out of the tank. Replace plug and add new oil to the tank.
Back of the seat remove the fender bolt..on both sides of the seat where your *** sits are two large torque bolts...You dont have to remove the tank Heritadge has fatbob tanks..remove the 1/2 inch nut holding down your speedometer raise it up and your wire will run through their. you have two seperate tanks their is space between them on the frame.
×