Would zzr end cans fit my zzr400 - ZZR 400 kawasaki Motorcycles

have a look here 1st
ZZR 400 twin cam Google Search
then maybe here.
https://www.google.co.uk/url?sa=t&rct=j&q=&esrc=s&source=web&cd=6&cad=rja&uact=8&ved=0ahUKEwjUj7T3yb_UAhVHBBoKHVL-DFEQFggzMAU&url=http%3A%2F%2Fwww.justanswer.com%2Fmotorcycle%2F1hntb-i-m-looking-cam-timing-marks-zzr400-kawasaki.html&usg=AFQjCNHRgexpNCMgJt3gtHTHKQTVJREXEA&sig2=3Zq9vr7IifJ3Z9qD536HMQ
hope its a help

Hi I have a zzr 400 kawazaki it starts but it dont want to reg up

think it will go stright in....as the zzr400 is the same the 600 apart from engine

spary wd-40 on all electrical connection that was expossed to water liberally.....if that doesnt do it, then you probably got water in your pulse generator system coils and will have to pull the cover off and see if theres water in there.

Hi and welcome to FixYa,

To my knowledge, 1 3 4 2. Electrically, leftside ignition coil powers sparkplugs 1 & 4, right side ignition coil powers 2 & 4.

Good luck and thank you for using FixYa.

zzr 600 manual is the same except the head and carbs

My kawasaki has the same noise, specially when cold, but this should go off when your bike temp goes 1/4.thats my observation with my ZZR400

hi m8,,b4 i can assume anything else,just a couple test u need to try out,, make sure fuel is getting in carbs ,,just undo carb drain screw and check fuel is in the carbs ,, just to iliminate 1 thing,, then pull off one plug cap at a time take the plug cap off the ht wire of the coil, and snip a bit off the end ,, so u can see a strand or to of copper or brass wire in the core off the ht wire,, then screw the cap back on, repeat the process to all the other 3 plug caps,, while u r there make sure the coloured wires to the coil arnt pulled off or corroded,,cheers

Its Starter relay may be causing main problem. You can try Yezdis starter relay as it can help you solving your problem

Hi!
Not being well familiar with the ZZr's however what is the Red LIne on this particular model? if it is around 10.000 then your rev limiter is kicking in stopping you blowing the engine.
Hope this helps!
Paul 'W'
Onyer~EDson(:0) {#><U.K.