Check engine MIL light on
?€¢
The MIL illuminates during a bulb test and a system test.
?€¢
A DTC will be stored if a MIL is requested by the diagnostic.
You could have a bad instrument cluster ! Here is part of diagnostic flow chart for your vehicle !
1
Did you perform the Diagnostic System Check-Engine Controls?
Go to Step 2
Go to Diagnostic System Check - Engine Controls
2
Is the MIL illuminated?
Go to Step 3
Go to Step 5
3
?€¢
The MIL turns OFF after the engine is started if a diagnostic fault is not present.
?€¢
The MIL remains illuminated after the engine is started if the control module detects a fault. A diagnostic trouble code (DTC) is stored any time the control module illuminates the MIL due to an emissions related fault. The MIL turns OFF after three consecutive ignition cycles in which a Test Passed has been reported for the diagnostic test that originally caused the MIL to illuminate.
?€¢
The MIL flashes if the control module detects a misfire condition which could damage the catalytic converter.
?€¢
When the MIL is illuminated and the engine stalls, the MIL will remain illuminated as long as the ignition is ON.
?€¢
When the MIL is not illuminated and the engine stalls, the MIL will not illuminate until the ignition is cycled OFF and then ON.
1,627 views
Usually answered in minutes!
×