2004 Jawa 350 Tramp Logo

Related Topics:

A
Anonymous Posted on Jun 23, 2014

1987 jawa cutch problems what can i do to get it working 100% pulling away is a mission and keeps deing?

1987 jawa 350

1 Answer

Donald Gunn

Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

Habit-Forming:

Visited the website for 3 consecutive days.

Hot-Shot:

An expert who has answered 20 questions.

  • Contributor 69 Answers
  • Posted on Jan 09, 2019
Donald Gunn
Contributor
Level 1:

An expert who has achieved level 1.

MVP:

An expert that got 5 achievements.

Habit-Forming:

Visited the website for 3 consecutive days.

Hot-Shot:

An expert who has answered 20 questions.

Joined: Feb 06, 2009
Answers
69
Questions
0
Helped
21964
Points
95

If the clutch is engaging but the motor is dying its probably a dirty carb jet, float or fuel starvation.

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

How to get conflict global storm all medals

There are 6 medals of all
And earned by how much u kill
1 = 40 kills
2 = 50 kills
3 = 60 kills
4 = 75 kills
5 = 90 kills
And last medals 100 kills
To get last medals u must ;
- already lv colonel
-all character have 5 medals
-do that before pressure drop mission and playing for keep mission because on 2 mission of that you cannot earn last medals

Note: learn how much total enemy in every mission..
Do 2 character every mission to earn every medals (except first mission) because total enemy in first mission only 60 enemy or less..

0helpful
1answer

I recently rebuilt a 1960's model 350 Jawa 2 stroke twin engine using a later model crankshaft assembly,with needle roller small end bearings.But the pistons still use the three cast iron rings.My question...

Ken,
I think you have gone as far as you can with what you have. A damn clever job by the way. The issues you run into with the 2 ring vs. 3 ring piston on your bike is piston slap as the skirt length changes with a 2 ring setup.
5helpful
1answer

Ignition Timing Settings

All Jawa's have the same timing requirements.
2.3 to 2.8mm BTDC
0helpful
1answer

Cluster lights blowing fuses - Temp gauge stopped working

try changing the headlight switch,I had a similar problem only mine happened after I accidentaly short out when I was replacing the horn pad and for some reason when I replaced the headlight switch the problem went away.
0helpful
1answer

Identificacion del carburador

Open the air filter and while the jeep is running place ur hand on the throttle very carefully, then in the other hand spray in STP CARB CLEANER. one spray then throttle up the carb so the engine keeps running.

Spray Again the carb and pull the throttle to high and back down after each spray.

4 times is enough.
0helpful
2answers

James Bond Quantum of Solace Mission 3 opera house.I cannot cross steel beam no matter how slow I go. I have tried at least 20 times

this should help http://www.youtube.com/watch?v=VVI8_-ItCXE
remember to kill all the people and disable all those cameras or your risk being seen when you jump the creaking beam alerts the guard above so only try to jump when he is away good luck
2helpful
1answer

Fuel gauge does not work

It sound's like you have a graound problem with the wire harness from the fuel tank. Check the connection from the tanks to the fram. Good luck.
0helpful
1answer

1987 k-5 blazer cranks and starts but won't stay running

Sounds like a large vacuum leak,low fuel pressure,fuel pressure regulator failure, idle air control valve stuck open,plugged fuel filter.Also check for good consistent blue spark at spark plugs or jumped timing chain.Hope this helps!
Not finding what you are looking for?

58 views

Ask a Question

Usually answered in minutes!

Top Jawa Experts

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

David Richard
David Richard

Level 2 Expert

57 Answers

Ngoro

Level 3 Expert

3521 Answers

Are you a Jawa Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...