Injector not working code po262 @
Hi, Anonymous for this scenario you will need your service manual that has all fastener torque specs -fluid capacities and a wiring diagram on the back pages, parts fiche, and owners manual if you can not find the best tool you ever bought for your Harley, despair not, for a mere zero $0 you can download another one.
For more information about your issue and valuable "FREE" downloads that you will need for viewing or printing please click on the blue links below and for more specific information or questions at no charge please feel free to contact me at [email protected]. Good luck and have a wonderful day.
https://www.youtube.com/watch?v=H4HYD69TyuE
http://www.mediafire.com/file/l6yf9cj68rct746/2004+Harley+Sportster+Service+manual.pdf
https://partsfinder.onlinemicrofiche.com/ronnies/showmodel.asp?make=hdmc
https://serviceinfo.harley-davidson.com/sip/content/document/view?id=89579
https://www.6ya.com/how-6ya-works to speak to me personally.
P0262 = FRONT INJECTOR HIGH
Possible causes
- Dirty Fuel Injector 1
- Faulty Fuel Injector 1
- Plugged Fuel Injector 1
- Fuel injector 1 harness is open or shorted
- Fuel injector 1 circuit poor electrical connection
Tech notes
Clogged or partially clogged fuel injector can cause this code. Start by performing an injector flush before replacing the injector.
Possible symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
- Engine Misfire
- Engine Run Rough
- Low MPG
P0262 Description
Code P0262 is triggered when the Engine Control Module (ECM) detects a low voltage in the Fuel Injector 1 Circuit. During normal conditions theECMturns the Fuel Injectors ON and OFF in the Fuel Injection System.
SOURCE: fault code po262. have changed injectors twice. checked wiring. looks ok could it be ecm
P0262 = Front Injector High EFI
One thing you can try is to swap the injectors front to rear, and see if now you get a P0264 error code.
If so, that tells me that the injector itself is the problem.
Sometimes one of the injector wires can break inside of the insulation and the wire will look fine.
You might try wiggling the injector wire while the engine is running and see if you get a code.
688 views
Usually answered in minutes!
×