- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
yes,i have the same bike,under the seat,and above battery should have a factory tool kit! it has the allen key for battery change,so all models have one, regards pete
Most often, access to the trunk is achieved by folding the rear seat down. If not, remove the seat and you'll have access to the trunk area.
If access isn't a problem, get yourself a plastic panel removal tool set from parts store and make sure it's not cold when you remove the panels as they'll be more likely to break from being brittle from the cold. Take your time.
There are two of them. One for each carb. The rear one is just in front of ht battery box under the seat. It can be removed by removingn the 4 screws under the right side cover. The front one is under the tank. you must remove the tank then remove the air box from the frame it's the black box near the handle bars. once the air box is removed the filter comes out the same as the rear one.
I just had to do this, and it isn't all that easy or quick. First, gently work the gray, carpet like cover loose from the area around the tail light ,(this may give you a little trouble). Once you have done this, you will see three silver nuts. These must be unscrewed. The lower left nut must be accessed through a hole next to where the trunk lid fits. (The screws are permanently attached to the lens housing so will not drop into obscurity when the nuts are removed). After removing the nuts, GENTLY work the lens housing away from the car. You may need a screw driver to unseat the housing, but just be gentle.
You will find three bulbs inside the lens. The brake light bulb is on the lower right side. Simply pull the old bulb out and insert the new one.
Just reverse these directions to reassemble the housing.
it is not designed to be removed. It is designed to slide back and forth as needed.
Section 01-10: Seats and Tracks
1998 Villager Workshop Manual
REMOVAL AND INSTALLATION
Seat, Rear
Bench Removal
Remove the center seat(s) if equipped. Refer to the procedure in this section.
Slide the bench seat forward to the center row seating position.
Use a flat-blade screwdriver to remove the cover caps from the front of the rear seat cushion latch cover.
Remove the two rear seat bolts from the front of the rear seat cushion latch cover.
Lift the rear seat cushion floor cover on the back of the rear bench seat and remove the two inboard rear seat bolts and the two outboard rear seat bolts.
Remove the bench seat from the vehicle through the body side door opening.
first take off the seat when the front seat is removed you will clearly see 2 10 mm bolts holding down the tank... you must also disconnect the fuel lines at the fuel shut off switch, i plug them with golf tees perfect fit.
Remove seat and gas tank. Plugs are at center of heads. Follow the cables (black cable about 1/2" thick. You will need a very long plug wratchet to get at them.
×