This bike had sat for a while, I have cleaned the crud out of the carb, cleaned the plug etc.. The bike starts fine but will not idle down. I have tried to adjust the screw on the side of the carb with no luck. Have tried the throttle cable-no luck. The start plunger seems ''sticky'' It does however go all the way to the bottom of its seat. If anyone has any other suggestions I would greatly appreciate them.
Thanks
Jeff
Remover all plastic/ rubber parts
then soak the whole carb body and slow jet in lacquer thinner
the slow speed jet/needle circuit needs to be cleaned with just 1 strand from 18 gauge copper wire going through all passages an holes pilot circuit in pic
Sounds like float,s sticking. Check float needle
1,737 views
Usually answered in minutes!
×