I have changed the crabs new plugs new coils start fine but no revs
Fuel system is clogged,..GARAUNTEED!! Take off the fuel tank,to get to the swirl bowl. Inside the swirl bowl,you will find a fuel filter,which SHOULD be completely white,and most likely,its not! Get a new filter and install it. While you have the tank off,disconnect the injector line,and remove and clean the injector with carb cleaner and pressured air.Put everything back together,and then add an INLINE FILTER to the feed line on the fuel pump which is located on the left hand side,running from the shut off valve,to the fuel pump. These are awesome quads,but the fuel injection system is a pain in the a$$.
Good Luck!
SOURCE: cold starting problems 1981 yamaha maxim 400
I had the same problem. I found that the ground on the wire harness under the seat was not grounded! It is worth a check.
SOURCE: ZZR400 turning but not firing
Dear hairybikeruk, Pl check your bykes relay. If its not working properly you may face the problem. It stops charging the battery though the battery might be a new one. Thanks.
Sunil Bhagwat
Mumbai
India
SOURCE: my keeway wont start
Check the fuses. Is the kill switch on or shorting out? Disconnect it and then check for spark. Sidestand/centerstand should be up, Got a good battery?
I am unfamiliar with your Keeway and just trying to help. Don't give me a bad rating if I miss the mark on this one. Thanks.
SOURCE: my rs250 keeps misfiring on one cylinder checked
replace the cdi unit buddy thats the only option im not too sure about the rev counter but get back to me with more info
SOURCE: 1995 yzf 750 wiring diagram, starts wont rev
Hi and welcome to FixYa,
Would the wiring of a 95 YZF750 R/SP European model help?
Good luck and thank you for asking FixYa.
Testimonial: "the blue yellow black wires i was looking for appear to be for tps unit whitch is missing thanks this gets me going in correct direction "
211 views
Usually answered in minutes!
×