I have a 2008 husky sm 610 - injection. I bought it the lst week and it was working well. 100km done with no problems. A day later, cold engine or warm has this area between 4000-6000rpm, when I do a full throttle it doesn't pull, just like it is going to die, and then again after 6000rpm pulls normally? I have changed the spark plug, but no difference. Help, please!
SOURCE: does 610 electric start engine fit in 610 kick start only frame
hi, i have a te610e and the 98-03 engine has a different exhaustand electrical system to the te610 kickstart only. it also has the chain/sprocket out the other side of the motor so the rim has to get turned around and chian guides and guard need to be fitted from the 610e. hope this helps
SOURCE: 92 model te-610 wont fire over
is the air gap at the ignition pickup correct is the plug cap & lead in good order ie no visible cracks in either lead or cap check the conections at the coil are all fuses serviceable try these for a start if no luck get back to me
SOURCE: husky parts finder
I suggest you Google "Husky Parts" and include your zip code if you are in the USA.
SOURCE: engine hard to start when
That's so simple problem , Change your sparkplugs with a Super Bosch.
SOURCE: Just bought my first Husky
I would say that the starter needs an overhaul and a clean out and relube. Be careful when lubricating the shaft, If the oil is the least bit thick or too heavily applied the pinion will hang up. For the rest, starting the bile is just a case of getting the sequence of the start right for that machine. When I got my Velocette (500 cc single) very long ago, it took me over half an hour to start the first morning, and no electric starters. Soon I was starting it first kick every time.
186 views
Usually answered in minutes!
×