20 Most Recent
2005 Triumph Triumph Bonneville Questions & Answers
I have a 2005 triumph bonneville and the engine
Check below the engine around the motor mounts beneath the engine for broken wire or disconnected wire. I once had this problem with a 69 Bonne and it was a disconnected wire underneath. Could be disconnected around the ignition area as well....It's a wiring problem for sure.
NEED THE VALVE CLEARANCES FOR
Hi,
For the record the clearances are:
Inlet: 0.15-0.20 mm
Exhaust: 0.25-0.30 mm
Let me know,if needed further assistance.
Hope i helped you.
Thanks for using ' Fixya ' and have a nice day!!
Bike wwould not run today without choke pulled all
You are correct, the mixture needs altering.
Start up with the choke in position were it will start, run a few minutes to warm up engine.
Turn mixture screw all the way in, don't screw hard in (Gentle) could damage screw seating, listen to engine when it starts to faulter gradually turn screw out, listening to the engine sound till she is running smooth on tickover. Reve up quick shut down on throttle, and if setup correctly should return to tick over without stopping. Lucky person.
Where is the coil
Hi
Ignition coils are mounted on the frame under the tank !!
Remove seat & tank
Ride safe
Bike-Doc
Please mark this as very helpful (if it has been!!)
Wires to flasher unit on 1977 triumph bonnivlle
The wires for the rear indicator lights should be under the seat on each side and the front ones should be in the headlight shell, the flasher unit is also in the headlight. The wires to the flasher unit should be a white and a light green/brown.
4/5/2015 4:26:08 PM •
Triumph...
•
Answered
on Apr 05, 2015
Not finding what you are looking for?