20 Most Recent
2008 Suzuki GSX 1300 R Hayabusa Questions & Answers
Shorted my 2008 hayabusa putting jump pack lead around the wrong way now no power any idea whats blown the blue fuse seems ok
Most probably the battery has shorted out. Check all fuses then fit a new battery if you re lucky the battery is the only thing that has fried. If nothing works when your new battery is fitted check the regulator/rectifier and further back to the alternator if necessary.
Please never use jump start packs or car chargers to start your bike. Also never jump start from a car etc. using cables.
Your poor little battery is not designed to take the amount of the current these units give out. Only use a dedicated bike battery charger with an output of 1 Amp maximum. Please also when removing the battery undo negative first when refitting connect positive first.
Water in oil
DONT run any more till you can figure out problem, probably a faulty seal or O RING
Hayabusa lazy starter
Instructions
-
-
1
Remove the rear cowl using the ignition key. Use the 5mm
Allen key to remove the two bolts securing the seat to the frame. When
the bolts are out, lift up at the back and remove the seat.
-
2
Remove the prop fuel tank prop rod from the rear storage area. Lift the back of the fuel tank and support it with the prop rod.
-
3
Unplug the fuel injector wiring harness connector. This is a
white connector that has wires coming from the fuel rail and connects
to the main wiring harness.
-
4
Locate a spot in the rear storage area to mount the Power
Commander unit. Clean the spot using brake cleaner and a rag. Mount the
Power Commander unit to the spot using the Velcro tape supplied with the
Power Commander.
-
5
Route Power Commander's wires along the frame rails towards
the front of the bike. The wires from the Power Commander have two
connectors. Plug each connector from the Power Commander to the white
connector you unplugged in Step 3. The connectors will only plug into
each other one way.
-
6
Lower the fuel tank and reinstall the seat. Start the engine
and follow the procedures for programming the Power Commander according
to the instructions in the manual.
Motorcycle wont start
Is the gas new?If it isn't,there was a report about how ethanol is causing problems in gas lines and motors.It erodes the non metal parts in the fuel system.You can try cyphoning the gas,add octane boost,then add some gas.My mechanic recommended it because I was at wits end and out of ideas so I called.A couple gallons is fine because if it doesn't work,you won't waste much money.I had the same problem,same time sitting on a scooter and it didn't work.It's all I got for now.Isn't it WONDERFUL that we're going green?
Good luck bro!
Not finding what you are looking for?