Replacing 91 suzuki gs500e clutch
Hi, if you are ok doing this type of job, then its quite easy to fit a cable, remove the seat, undo the 2 bolts securing the fuel tank and prop up the back end of the fuel tank, remove the gear change lever by removing the 10mm bolt, remove all the screws holding the sprocket caseing, next comes the cable with the case still on the engine undo the locking nut on the clutch cable, (12 mm), next get the new cable and lay it along side the whole length of the old cable and fasten it to the frame where ness, screw in the addjuster all the way at the clutch lever and align the slot for cable removal from the lever now remove the sprocket cover and old cable with it, undo the cable adduster all the way until it is removed from the case, push the cable wire back to remove it from the clutch control arm inside the case, try not to remove the arm as it will fit back in more than 1 position, retaining the original position is important, you can then refit the new cable into the arm a small amount of grease on the cable nipple will help, replace the case back onto the engine it should fit flush with no effort, replace all the screws, it important they are fitted in accordance, so place them loosly in the holes they should all protude around the same amount, if any are shorter or longer move them around untill correct. Once happy tighten them up, connect the cable at the control lever on the handlebar and then remove all the slack from the cable at both ends untill you have around 5mm free play at the handlebar end, replace gear change lever, and all other fixings.