20 Most Recent
1996 kawasaki ZZR 600 Questions & Answers
Was riding my ZZR600E out locally last week
You can check the primary and secondary resistances in the coils, dont know offhand the values, but the coils should be the same.
The fact is gets worse as it warms could mean a carb float is flooding,
The vacumn fuel tap can be a problem, this can also cause fuel to flood into the sump , and cause this problem.
Other than the battery, what would cause my bike
fuel pump not working, fuel filter clogged, spark plugs fouled or plug wires loose, or ignition system is weak, check coils and pulse generators and check for loose connectors also.
Does the bike push start?...if it does, then then everything i"ve just told you is working and the carburetors/fuel pump is probably dirty. Purchase a can of Sea Foam from Autozone pour 1/3 can to two gallons fuel, push start it now it will probably run a little rough so keep it going and ride for about 10 miles or so...if you have a carb problem this stuff will clean out your whole fuel system..let me know if this helped you thanks.
Ticking noise in 6th mainly on deceleration
Check your chain and sprockets, sometimes the chain wears the sprocket out, "curving" the teeth so it hooks the chain. You probably have the ticking in lower gears as well, but it only hooks the chain at speed - and in 6th the engine revs are lower, the engine is quieter, so you hear the chain easier.
Kawasaki zzr600e wont start
If you are not getting the starter to wind after pressing the start switch check these probs.Have you checked the fuses for the ignition switch? Check all fuses. Track the wiring from switch and check all plugs and connections.
Turn ignition on and try clutch starting the bike to see if the motor will run once it is cranked over.
If you need to bump it, make sure all your connections and wiring are all making good contact.
You must conduct a process of ilimination in order to rectify the fault.
good luck.
Kawasaki front brake problem
you need to bleed the brakes real good you have air in the line or caliper this happens when you disassemble the caliper hope this helps give us a rate
How do i replace the fan motor
When u have fairings off there are 3 or 4 bolts that hold the fan housing on remove them and disconect the wiring and your fan motor should be easy removed with one or 2 screws holding I
Tyre presure
The pressures should be listed in your manual depending on the type of tyres (tires?) you're using. Set this pressure and away you go. It will list details of what to change if you have a pillion passenger but as far as I'm aware the pressure quoted should work both with and without
I have a 1996 ZZr600. It tends to stall when
It would seem as if you have the idle set too low. When the lights are on it is putting more strain on the engine, so when it is idling it causes the engine speed to fall too low.
No spark
It is either the stator, pulse generator, or CDI. My guess would be the CDI
Not finding what you are looking for?
