20 Most Recent
2004 Honda CRF 150 F Questions & Answers
2004 Honda CRF 150 F sticky throttle
Disassemble throttle clean and lube it. Disconnect the throttle cable at the bottom end and use some spray lube at the top end. Let gravity do the rest of the work until you see oil come out the bottom of the cables than reassemble everything.
2004 Honda CRF 150 F engine oil capacity
Hi Anonymous, I hope I'm not to late in answering your question!
There are 2 oil cavities. 1 for trans and 1 for the motor. if u change the filter and the engine oil its like 600cc's just the oil it's 550cc's or so.
Kind regards
David
How to start a honda crf150f in cold weather
The way I start any of my bikes in cold weather is turn on the choke and once its turned on and run for 1 minute or so turn it off and warm your bike up. For the first few mins of riding don't go too extreme, since the cold air can cool your bike down quickly.
No shock fluid in rear shock. how do I put some
I would buy a new aftermarket one from a company such as Maxton, Hagon or one of the big suspension companies such as Showa or Ohlins. When you try to replace the fluid you will also need to find out where it is leaking from, and then fix it.
CRF 150 Honda 2007 oil change
Hi Niven
There are also 2 separate drains/fillers one for the transmission and the othe for the crankcase . The measure is 620 ml per side, although some guys run up to 700 ml on the transmission. 10W-40 is the correct weight for the engine side. On the trans side a Transmission specific oil in an 80W or 85W grade. Maxima Extra full synthetic is the best oil you can buy for the engine. Maxima MTL is the best for transmissions.
regards
robotek
When i push the choke lever to the top position
Hello, it sounds like a fuel delivery problem. Start with the fuel petcock, make sure it is clean and gas is flowing freely to the carb. Check for vacuum leaks.If that is ok, the idle/pilot jets & circuits are probably clogged & will need to be cleaned. I hope this helps.
Which way should u turn
anticlockwise. but do not forget that if the throttle cable is tight, then this will hold the throttle open anyway. make sure there is some free play in the throttle cable before trying to adjust the idle screw.
Only runs with full choke,
Hi mate reverse the needle clip position back to factory setting this issue is pilot circuit for sure - If you have cleaned carbi you need to replace or clean the pilot jet and compress air clean the hole where the pilot jet came out of to clear the circuit. Running only with choke on is classic symptom of block pilot circuit...
Also check you fuel air mix screw this may have been altered trying to correct this issue it should be 1.5 - 2.5 turns out from fully closed..
all the change of needle position clip is doing is allowing your bike to run off the main jet (not good)
and reason for running with choke on is it is changes air fuel mix with choke on compensating for lack of fuel from the pilot jet blockage
regards Jamie
Starts on the first kick
Clean your carburettor and make sure you have clean fuel, very common problem with a lot of bikes. You can try adjusting the idle up to get you going temporarily.
Not finding what you are looking for?