20 Most Recent
1996 Titan Gecko RM Questions & Answers
Rear tire is hitting the
As long as the tyre is of the correct size and fitment, and the wheel is aligned, you will have to check the security of the belt drive sprocket on the rear wheel, and the cushdrive in the rear wheel, grasp the rear pully on the top and the bottom, with the wheel tightened, check for exsess play in the bearing by pulling top and bottom, this would cause a problem, like you are having
I have a 150cc scooter .. when I start it up it is
You have to id the problem. The noise is only a symptom of the problem. You have to determine if it is a loose exhause, body panel, something loose in the transmission etc.
What kind of noise is it? Does the noise get worse or faster with engine speed? You need to give a little more information so we can have some more clues. Have a great day.
What does it mean when two cylinder comes across a dash of a Titan sidewinder '05 Softail
In the context of a Titan Sidewinder '05 Softail motorcycle, the phrase "two cylinder comes across a dash" doesn't have a standard or well-defined meaning. It seems to be a partial description or an incomplete statement, which may not convey a clear message to those unfamiliar with the specific motorcycle model or its terminology.
The Titan Sidewinder '05 Softail is a custom motorcycle model, and without further context or complete information, it's challenging to interpret the meaning accurately. It's possible that there could be a specific issue, feature, or part related to the motorcycle's engine or dashboard being referred to, but without more context, it's difficult to determine the exact meaning of the phrase.
If you have additional context or information about the motorcycle, feel free to share it, and I'll do my best to help clarify or provide relevant information.
8/5/2023 10:13:48 AM •
Titan...
•
Answered
on Aug 05, 2023
Need circuit diagram for ARLEC 15e 6-24Volt 15Amp Electronic battery charger OR their later model BC58
I can't find a diagram.
The small potentiometer on the control board likely serves as an adjustable component to fine-tune specific parameters. Here are some possibilities:
Voltage Regulation:
The potentiometer might control the output voltage. By adjusting it, you can set the desired charging voltage for different battery types (e.g., 6V or 12V).
Current Limit Adjustment:
It could be used to set the maximum charging current. Adjusting the potentiometer allows you to limit the charging current based on the battery's capacity and condition.
Sensitivity or Threshold:
Some potentiometers act as sensitivity controls. For example, it might adjust the threshold at which the charger switches between charging and maintenance modes.
Setting the Potentiometer:
Without the specific circuit diagram or detailed information about your charger, I recommend the following general steps:
Observe the Potentiometer:
Identify the potentiometer on the control board. Note its position and any markings (if present).
Consult the User Manual:
Check the user manual or operating instructions. It might provide guidance on adjusting the potentiometer.
Trial and Error:
If no specific instructions are available, start with the potentiometer set to its mid-position.
Gradually adjust it while monitoring the charger's behavior (e.g., charging current, voltage).
Observe how the charger responds to changes in the potentiometer setting.
Fine-tune it based on your specific battery type and desired charging characteristics.
Remember that precise adjustments depend on the charger's design and the battery you're charging.
4/18/2024 7:22:52 PM •
Motorcycles
•
Answered
17 hours ago
What is the length of lift cables on a 1993 model 2693 hilo camper and any info on what after market part to use ? thanks
The lift cables on a 1993 model 2693 Hilo camper are 30 feet,2 3/4 inches long and fit the standard height lift of 11 feet 8 inches high to the top of the overhead. The lift uses two cables. According to a Hi- Lo camper travel trailer forum, cable replacement is basically the same on all years and models, with the main difference being the length of the cables from model to model. You can use a cable cut chart to find what cable length you need for your camper, and you'll need to know your year, model name, and box (body) length: Lift cables typically wear out after three to five years, so it's important to replace them as needed and keep them regularly maintained.
4/12/2024 1:26:15 AM •
Motorcycles
•
Answered
on Apr 12, 2024
Not finding what you are looking for?