20 Most Recent
1989 kawasaki ZXR 250 Questions & Answers
I am doing this on behalf of my son,he has a 1989 kawasaki zxr 250,it had a ticking niose when riding,got worse the faster he went,took it to his motorbike mechanic,was told it was his starter motor,[
You could purchase a service manual for the 250.
Then you will need tools, some very special. You will need a place to work and
probably a mechanic friend to look over your shoulder from time to time. You
should speak with the parts guy or gal at the Kawasaki shop considering the
parts you will need for this 25 year old motorcycle. I'm sorry, you can not get
step by step instructions on how to reassemble an engine hereSince you
are this far along, you may well want to consider the actual condition of the
engine. Bore clean and smooth? Piston? Bearings, etc. You may also
want to consider the general condition of the bike. Consider, when
you are all done, you will have a very expensive 25 year old motorcycle. This is
not impossible but it will be an involved expensive project.
Timing
align the cam timming marks with the cylinder and the marks on the magnito with the marks on the case
My 89 250r wsa running then seemed to run on 1
try to star it with startin fluid to see if it is spark or fuel if it hits with the starting fluid u know it is fuel if nothing you need to start looking at the cdi or like u said timming but cdi is a better bet check stator as well my bet is it cdi or stator if u have no fire BUT MAKE SURE IT IS NOT FUEL FIRST
Zxr 250 parts
Sumota in melb,They also advertise in Just bikes.
(03) 9329 6444
Where do I find the netural start switch on my 89 zxr250?
The neutral switch is mounted in the left end of the shift drum. It is part number 13151-1080. There is an associated part, "PIN-neutral position" #92043-076 The pin is under a bolt screwed into the top case. Bad switch or loose wire connection.
Please rate this answer. Thanks!
Front brake locked on Kawasaki 300 atv
i would presume you have hyd front brakes? if so your return hole in your master cyc could be pluged.this would not let fluid to return to the resivouir. remove fluid and clean the tiny return hole on bottom of master cyc.Use comp air only
Cant find shims for '89 kawasaki zxr250
Hi .... You might have to go through Kawasaki or a good dealer may have some in his workshop. Do not sand or grind the ones you have as you will remove or reduce surface hardness. A good engineering firm (with an accurate lathe) could make you a few in Stubbs steel if you provide a pattern and state the sizes you require.
Tell me where you are based and I might be able to make suggestions.
Not finding what you are looking for?