20 Most Recent 2010 Peugeot Geopolis 250 Questions & Answers

could be warped brake disk if its got too hot anytime

If your Peugeot Partner has a new starter motor and is showing an electrical circuit fault, it is likely that there is a problem with the electrical system or one of its components. Here are a few things you can try to troubleshoot the issue:

1. Check the battery connections: Make sure the battery connections are clean and secure. If the connections are loose or corroded, it can cause electrical problems.
2. Check the starter motor: If you have recently replaced the starter motor, make sure it is installed correctly and that all of the connections are secure.
3. Check the electrical wiring: Inspect the electrical wiring in the engine compartment to see if there are any loose or damaged wires.
4. Check the alternator: The alternator is responsible for charging the battery and supplying power to the electrical system. If the alternator is not functioning properly, it can cause electrical problems.
5. Check for other issues: There could be other issues with the electrical system, such as a malfunctioning control module or a problem with the fuses. In this case, it is best to seek the help of a qualified mechanic who can diagnose and fix the problem.

I hope this information is helpful. If you have any further questions or need additional assistance, don't hesitate to ask.

Since the headlight pulls more current than most everything else on the electrical system (other than the starter) you should be able to pull the headlight out, take the electrical leads off, connect a low power charger or battery tender to them and then be able to activate the electric lock...you may even get the battery charged that way. Make sure that the headlight switch is ON.

https://scootergrisen.dk/.../peugeot_speedfight3_50cc_2stroke_technical_training.pdf

Fuse..switch or relay at fault. Inspect batt connections for corrode and titeness

Low oil is indicated by a steady red light (not flashing) so I guess the oil level is not the problem. Start off by just turning the ignition on and don't start the engine. You should only have the usual power lights and the oil light should be steady as no oil is being recirculated. If it flashes at this point, it is nothing to do with the oil pressure and points to an electrical issue elsewhere. If it is steady then start the engine and let it tick over. As you know, the red light should go out or at worst glow dimly until you rev the engine and that makes it go out as the oil pressure increases. If it starts flashing now I would suspect a relay somewhere clicking in and out and lighting the bulb. It is possible the immobiliser is playing up, especially if the battery has been disconnected, not enough of a problem to stop the engine from starting but enough to throw up an error somewhere.

Check for fuel, and fuel flow to carb. Often if an engine has been sitting for three months or more the carburetor jets may become clogged with fuel residues and need to be cleaned.

Check the wireing; any loose ends etc. Check the fuellines. Check if any cracks in the blocks etc.

under ur tank if it is a crouch rocket o and have fun lol

Replace clocks

my name is cassandra dugazon i am form haiti i like youtube