20 Most Recent
2009 Husqvarna TE 510 Questions & Answers
Why dose it keep stalling
you may want to check your air fuel mixture.
also check your vents and hosess if there may be any air leaks.
Coughing and splattering
have you had the dispack changed on any of this trips to the mechanic's as it sound to me to be this. it would take around 30 min for it to over heat if it had a fault. then you would get a low spark, no power and eventually just stop working all together.
Cant figure out how the timing goes
top dead centre the piston , crank timing mark should be on tdc , set cam up to be on tdc aswell ! if you didnt move timing back plate all be ok otherwise you need the setting !
2006 Husqvarna TE-610 only has intermittent spark one.
If you have already replaced the flywheel, stator, and CDI, the next step would be to check the ignition coil and spark plug. It is possible that the ignition coil is faulty and needs to be replaced. Check the spark plug for any damage or wear and replace it if necessary. Additionally, make sure all the wiring connections are secure and free of corrosion.
If none of these steps fix the issue, it may be best to take the bike to a mechanic or dealer for further diagnosis. They may be able to identify any other potential problems that could be causing the intermittent spark issue.
3/5/2023 9:12:58 AM •
Husqvarna...
•
Answered
on Mar 05, 2023
K970 won't start after rebuild
My first thought is that is the primer bulb in the right way round as effectively, it is a one way valve New bulbs also fail to work properly. I reckon that is why they come in packs of 10 :>D Take it off, connect it to fuel and make sure it pumps.
Also please note that we are not Husqvarna, we just have the category for easy filing.
11/29/2021 11:01:56 PM •
Husqvarna...
•
Answered
on Nov 29, 2021
Husky wr 250 wiring diagrams 1995 model
Most likely it will be the stater. And they are pricey. Coils hardly ever go bad or the only other thing that would cause a no spark problem could be the kill button. I hate to say it, but i think it will be the stater.
4/2/2019 12:32:00 PM •
Husqvarna...
•
Answered
on Apr 02, 2019
Husqvarna Z turn changed the rectifier and the battery and something is still killing the battery
Ok.. The rectifier only changes AC voltage to DC voltage.. the voltage to charge the battery comes from the generator.
With the engine running at half throttle+, and IN NEUTRAL, check the voltage at the battery terminals it should be 13 volts +. If you are not getting at least that much.. make sure all connections are tight.. if its less than 13V..... more checking is indicated. (Shop time)..sorry...
6/13/2017 11:52:58 PM •
Husqvarna...
•
Answered
on Jun 13, 2017
Not finding what you are looking for?