Husqvarna Motorcycles - Page 7 - Recent Questions, Troubleshooting & Support
Clutch was slipping now cant get inti gear
did you replace clutch - plate bolt tension may be incorrect -
if you messed with the cable adjustment - you may have it incorrect -
I believe that if the cable is too loose then the clutch will not disengage, and the drag makes shifting a problem
I got a Husqy TE
Hi. Can you please advise where the serial number and VIN number are on the TC450 (2004) model
thanks Darryl
How do I go about Timing the Cam
it hase a litle sign at ignition at the electrics if you cant find it remove the spark plug and put carefully a screwdriver. top dead center is upper place that the piston can be..for the timing every camhas a sign in the gear that maches with a sign at the waterpump gear wen it is at the center.sorry for the ad english if i didnt help and you dont have already a solution send an email so i can send you photos.
Spitting gas out overflow from crankcase
What model and year? Because if it is a 4 stroke you have serious problems. If it is a 2 stroke then depending on how much will indicate something of the problem. 2 strokes use the crankcase to pressurise the mixture before feeding it to the combustion chamber. 4 strokes should never have fuel in the crankcase. It would indicate a hole in the piston or failed piston rings.
5/13/2013 9:53:48 PM •
Husqvarna...
•
Answered
on May 13, 2013
I change seal on water pump twice and oil in gearbox is still grey???Husqvarna WR300-2012????
after you changed the seal did your water level drop If the seal is still leaking you should see a change in coolent level Also did you flush the motor with solvent if not it could take more than 3 oil changes to see a change hope this helps I currently race 2 husky 125 2 stokes off road anand i dont know of another way to get water in the oil except thruogh the overflow and that takes some serious waterplay good luck dirt bike dan
Can't keep blower engine going
more than likely your primer bulb diaphram is bad or it could be you have a crack in the gasline that goes into the gas tank or maybe a small crack in the gas tank .... these small cracks wont allow any pressure to build up in the tank to provide the engine with the fuel needed to run. hope that helps
3/9/2013 6:11:34 PM •
Husqvarna...
•
Answered
on Mar 09, 2013
Not finding what you are looking for?