Husqvarna TE 250 - Recent Questions, Troubleshooting & Support
Brand new battery ran out
I would check the output voltage of the regulator, if none or low, go to the altenator and check the diode pack.
Hope this helps.
Brand new battery not chargeing
If there weren't any problem with recharging the old one the new battery is probably defective, ask the seller to change it for a new piece. Otherwise it may be a problem with alternator (A.C. generator)
Describe your how to kick
Ease the kick start lever just past TDC (top dead center) compression. This puts the piston on the downward power stroke. Twist the throttle one time. Now kick it over. Don't twist the gas with every subsequent kick. A power valve squirts gas with each twist and can flood the engine really quick. A fresh spark plug, clean air filter and good battery will also help. Drain the carb to be sure no water has gotten into it.
Service intervals
really depending how much u ride it, change your oil 1-2 times a month with a clean filter too no matter wat anyone else says. change the coolant once every 6 months
My 09 te 250 starts well and runs well but if i
Try removing and draining the tank. Sediment can build up restricting fuel flow, I install in-line fuel filters on my bikes, to keep impurities out of my carbs. I also use fuel additives, (carb cleaner, gas treatment) on a regular basis to keep them running smoothly
Extra wires.
More often than not, the extra wires are used as a gateway for a diagnostics report. dnt no if that helps
Flat spot off idle when cold.would like to know
hi,sounds like the bike is running a little to lean,it will take some mucking around but it is worth doing,buy yorself a set of main jets in steps of 5..ie if your bike has a 100 main,then go get them at 105,110,115,120,125 etc,and just keep swapping them out untill your flat spot disappears,the other option is lifting the needle valve in the carb slide it will achieve the same sort of result but you wont have the adjustment,,most bikes are set at the factory to an average atmosphere and that obviously changes with altitude,it shouldnt take much to get it right...cheers
My 2007 husqvarna is breaking the spark plug.
It sounds as if you have the wrong spark plug and it cannot handle the compression of your motor. Go to this site and get a freebie manual, it may have the necessary information so that you can cure it.
http://www.carlsalter.com/motorcycle-manuals.asp
Huskt tc250 broken inner an outter case round kick start
Obviously, new casings would be the best option, but another option you have is to take the parts to a commercial welding shop and have them Heiliarc weld the casings. Alternate to that, you could try Googling motorcycle salvage Husqvarna to see if you can get some used parts. The bad thing about a busted inner casing is that you should change out the inner casings as a matched set. Sometimes the casings don't line up perfectly if only replacing one side and the result is shafts that freeze up when you tighten down the screws. Please rate my answer. Thanks.
How do I change from KPH to MPh on 2009 TE250
Hi
I am assuming that the speedo for the 2009 TE250 works as for earlier models. Check out page 57 of this manual
here(right click and "save" ) Gives you the method for changing the miles to k/hr. There is a button on the rear of the unit that you need to depress for at least 5 seconds until the unit goes into "WS" mode, then change the settings with the front panel button as per the instructions. Press the right, then the left button and it should go into mph. Then press the rear button for 1 second to go back to operation mode.
Thanks for using FixYa, Let me know how you get on. Cheers.
regards
robotek
Not finding what you are looking for?